SMC Networks 6152PL2 Management Manual page 544

4
Command Line Interface
Use this command to configure the port response to a host MAC authentication
failure. Use the no form of this command to restore the default.
Syntax
mac-authentication intrusion-action [block traffic | pass traffic]
no mac-authentication intrusion-action
Default Setting
Block Traffic
Command Mode
Interface Configuration
Example
Console(config-if)#mac-authentication intrusion-action block-traffic
Console(config-if)#
Use this command to set the maximum number of MAC addresses that can be
authenticated on a port via 802.1X authentication or MAC authentication. Use the
no form of this command to restore the default.
Syntax
mac-authentication max-mac-count count
no mac-authentication max-mac-count
count - The maximum number of 802.1X and MAC-authenticated MAC
addresses allowed. (Range: 1-1024)
Default Setting
1024
Command Mode
Interface Configuration
Example
Console(config-if)#mac-authentication max-mac-count 32
Console(config-if)#
4-166