Table of Contents
Advertisement
Check the following items before you contact SMC Technical Support.
1. If mobile users do not have roaming access to the SMC2655W access
point:
Make sure that all the SMC2655Ws and stations in the ESS in which
the WLAN mobile users can roam are configured to the same WEP
setting, SSID, and authentication algorithm.
2. If the management utility cannot connect to the SMC2655W:
Check that your local IP address settings conform to the SMC2655W
settings.
3. If you forgot your password or your SMC2655W has locked up, you
can reset it to factory defaults by performing the following steps:
•
•
or
•
•
•
•
•
•
22
T
Start the utility program.
On the main menu, click "Command." Click "Reload Default."
Power off the SMC2655W.
Use a pin to push in the reset button located on the bottom of the
SMC2655W (marked "Reload." )
While holding in the button, apply power to the AP.
The AP will begin to load the default settings.
Wait for about 5 seconds. Release the button.
The AP will restart with the factory default settings.
ROUBLESHOOTING
Advertisement
Table of Contents
