Section 3 - Configuration; Configuration (Set Up) - Partlow MRC 7000 Installation, Wiring, Operation Manual

Configuration 3.1
After completing installation and wiring of the instrument the configuration (set up) procedures
must be performed to prepare the instrument for operation on the intended application. The
procedures include selecting specific parameters, entering data and possible jumper position-
ing. Once properly configured the instrument will retain the user selections in memory so this
procedure need not be repeated unless required by changes in the application.
Parameter selections and data entry are made via the front keypad. To ease configuration
and operation, user entered data has been divided up into several sections referred to as
modes. Each mode contains a different type of data or may be used for specific operating
functions. For two pen instruments, some modes are common to both pens. These modes are
as follows:
MODE DISPLAY CODE
Off
Control
Test
Calibration
Program
Tune
Profile Entry
Profile Continue
Setpoint Change
Enable
Associated with each mode is a series of unique displays that are accessed via the front
keypad.
FUNCTION
oFF Operation
CtrL Control
tESt Service
CAL Service
Prog Configuration
tunE Configuration &
Operation
PEnt Configuration
PCon Operation
ESPC Operation
EnAb Configuration
DESCRIPTION
Outputs and Alarms
are Off
Chart may stop
rotating(selectable)
Outputs and Alarms
are Active
Tests Instrument
Operation
Calibrates, Resets
Instrument
Configure Operating
Parameters
Enter Tune and
Alarm Settings
Enter the Profile
program(s)
Provides the means
to restart the profile
anywhere within the
program
Prohibits setpoint
change from the
keypad
Mode security
system, can lock out
everything except Off
and Control (See
Appendix A-1, page
67, for hardware
lockout information)
21