ENGLISH 01 Introduction Congratulations on your DucoBox Silent, the quietest box in Europe! The DucoBox Silent performs two functions in a DUCO Demand-Controlled Natural Ventilation System: On the one hand it is the extractor fan that exhausts stale air with excessive CO content or humidity�...
• Bends in the ducts immediately upstream of the fan unit. • The DucoBox Silent must not be connected to a (motorless) extractor hood or tumble dryer. Take care to ensure that the electrical power supply is a 230 V, single- It ought to be impossible to touch the fan by hand�...
10 UNMISSABLE TIPS connections Keep down restriction� A non-return flap is The smooth running of your Duco ventilation system is totally dependent on the choice and the quality of implementation of the duct system! required when discharging into a manifold�...
HIGH INST the DucoBox� 05.B Wiring diagram The DucoBox Silent communicates with components through a wireless (RF) DUCO RF connection� RF components have a maximum free-field range of 350 metres� This Power supply 230 VAC distance will be much less in a building because of obstacles� Therefor you will need Wiring 1,5 mm²...
This can be done using the Duco Network Tool*� This us- er-friendly software also enables problems in the system to be pinpointed� The Duco Network Tool is issued to every installer after attending a free training course at the Duco Academy*� Please refer to our website or your DUCO dealer for further information�...
(see table in the next section)� ‘Installer mode’ can be activated by pressing the DucoBox Silent Connect ‘INST’ button (see drawing in section "05�A Connections & buttons" on page 9)� When the LED on the controller starts flashing green, 'Installer mode' is active� Press ‘INST’ again to return to ‘User mode’...
DucoBox� Once all components have been paired, ‘Installer mode’ can be deactivated by tapping ‘INST’ on the DucoBox Silent� The LEDs on all components will stop flashing� Please refer to the manual with the components for more detailed information�...
• Restore factory settings for the DucoBox and all paired components (AS FROM DucoBox version 18xxxx): Long-press ‘INST’ and ‘ENTER’ if not in ‘Installer mode’. The network remains in place� • Use the Duco Network Tool to read out information from components� 08 Air calibration For the system to operate correctly, the air volume must be adjusted�...
Page 14
LEDs of the 'AUTO' button on the User Controllers / Room Sensors turn white, and the LED on the DucoBox turns white� * Depending on the software version of the User Controller� L2000651 Installation guide for DucoBox Silent (Revision P | 24.01.2025)
All warranty conditions concerning the DucoBox and DUCO's ventilation systems can be found on the DUCO website� Complaints must be made in writing to DUCO by the installer or the DUCO distribution point, clearly stating the complaint and the order/invoice number with which the products were delivered� To do so, please fill out the complaint registration form, found on the DUCO website, mentioning the serial number and send it to service@duco�eu�...
Page 16
Installed by: L2000651 Document last modified on 24.01.2025 (revision P)
Need help?
Do you have a question about the DucoBox Silent and is the answer not in the manual?
Questions and answers