Advertisement
DB1 Remote Control
PLEASE READ THIS MANUAL BEFORE USING.
PLEASE RETAIN THIS INFORMATION FOR FUTURE REFERENCE
DB1 RC T. Rex Setup
Tail Installation
After aligning the interface, install the tail on the dinosaur from top to bottom
*product colors may vary
Dinosaur Battery Installation
Install 3*AA batteries into the dinosaur with the corresponding polarities as labeled on the unit. Then close the battery cover and tighten the screws with a screwdriver.
Fill Up The Smoke Chamber
Before using DB1, fill the smoke chamber with water using the included bottle.
Fill the included bottle with water. Then open the lid of the head, use the included bottle to add water.
Remote Battery Installation
- Use a screwdriver to remove the battery cover.
- Place two AA's with the corresponding polarities as labeled on the unit.
- Replace the battery cover and screw back into place.
Battery Warnings
- Insert batteries with correct polarity.
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
- Rechargeable batteries are to be removed from the drone before being charged.
- Rechargeable batteries are only to be charged under adult supervision.
- Exhausted batteries are to be removed from the drone.
- The supply terminals are not to be short-circuited.
- In order to avoid battery leakage causing damage to the remote controler, please take out the battery if not in use for a long time.
CONTACT INFORMATION
E-Mail: support@contixo.com
Website: www.contixo.com
Documents / Resources
References
Download manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Need help?
Do you have a question about the DB1 and is the answer not in the manual?
Questions and answers