Contixo CV2 Manual

Table of Contents

Contents

Contixo CV2 Manual

CV2 Remote Control Excavator Setup

warning PLEASE READ THIS MANUAL BEFORE USING.
PLEASE RETAIN THIS INFORMATION FOR FUTURE REFERENCE

*When removing the battery to charge, take care to unclasp the connector before pulling it off.

Battery Installation
*product colors may vary

Use a small phillips head screwdriver to remove the battery cover.
Place two AA's battery (Not included) with the corresponding polarities as labeled on the unit.

Remote Battery Installation

Install the guardrail to the corresponding socket on the engineering vehicle. Guardrail Installation

Batteries must be loaded with the right corresponding positive and negative electrodes.
Do not mix old and new batteries.
Do not mix different types of batteries (types or brands).

The light turns on when charging and turns off when it is fully charged.
Use only the original factory cable. Do not use damaged or cable of other brands.
Do not charge expanded, leaked, or damaged batteries.
Do not overcharge the battery. When the battery is fully charged, unplug the device.
Do not charge near flammable materials (eg. carpets, wood flooring, solid wood furniture, ets.).
Do not charge the battery immediately after it has become hot.
The charging temperature of the battery should be between 0-40°C (32-104°F).
Recommend using a 5V 1A charger (Not included) for charging.