Advertisement
Table of Contents
Contents
Contixo DR1 Manual
DR1 Remote Control
PLEASE READ THIS MANUAL BEFORE USING.
PLEASE RETAIN THIS INFORMATION FOR FUTURE REFERENCE
Demo button
Click the button on the Velociraptor, the Velociraptor will automatically demonstrate the function.
*product colors may vary
DR1 RC Roaring Raptor Setup
Remote Battery Installation
- Use a screwdriver to remove the battery cover.
- Place three AA's with the corresponding polarities as labeled on the unit.
- Replace the battery cover and screw back into place.
![Setup - Remote Battery Installation]( "Contixo - DR1 - Setup - Remote Battery Installation")
The dinosaur has been installed batteries, please remove the insulating tape from the batteries before use.
Tail installation
Push the tail on until it "clicks".
Battery Warnings
- Insert batteries with correct polarity.
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
- Rechargeable batteries are to be removed from the drone before being charged.
- Rechargeable batteries are only to be charged under adult supervision.
- Exhausted batteries are to be removed from the drone.
- The supply terminals are not to be short-circuited.
- In order to avoid battery leakage causing damage to the remote controler, please take out the battery if not in use for a long time.
CONTACT INFORMATION
E-Mail: support@contixo.com
Website: www.contixo.com
Documents / Resources
References
Download manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Need help?
Do you have a question about the DR1 and is the answer not in the manual?
Questions and answers