Contixo DR3 Manual

Also See for DR3:

User manual (5 pages)

Table of Contents

Contents

1 DR3 Remote Control
2 Demo button
3 DR3 RC Dragon Setup
4 Battery Warnings
5 CONTACT INFORMATION
6 Documents / Resources
- 6.1 References
- 6.2 Download manual

Contixo DR3 Manual

DR3 Remote Control

warning PLEASE READ THIS MANUAL BEFORE USING.
PLEASE RETAIN THIS INFORMATION FOR FUTURE REFERENCE

Remote Control

Demo button

Click the button on the Dragon, the Dragon will automatically demonstrate the function.
Demo button
*product colors may vary

DR3 RC Dragon Setup

Wing Installation

Insert the wings into the bracket on the dragon's back and fix it with the screws in the accessory kit.

Fill Up The Smoke Chamber

Before using DR3, fill the smoke chamber with water using the included bottle.
Fill the included bottle with water. Then open the lid of the head, use the included bottle to add water.
Fill Up The Smoke Chamber

Remote Battery Installation

Use a screwdriver to remove the battery cover.
Place three AA's with the corresponding polarities as labeled on the unit.
Replace the battery cover and screw back into place.

The dinosaur has been installed batteries, please remove the insulating tape from the batteries before use.

Tail installation

Push the tail on until it "clicks".
Tail installation

Battery Warnings

Insert batteries with correct polarity.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
Rechargeable batteries are to be removed from the drone before being charged.
Rechargeable batteries are only to be charged under adult supervision.
Exhausted batteries are to be removed from the drone.
The supply terminals are not to be short-circuited.
In order to avoid battery leakage causing damage to the remote controler, please take out the battery if not in use for a long time.