NexiGo NXG-PS5D-0506WHT Manual

If you have any problems please contact us at cs@nexigo.com at any time for further assistance. This product is covered by our generous 1-year manufacturers warranty, please visit www.nexigo.com for more warranty information and register on www.nexigo.com/warranty for an EXTRA ONE YEAR warranty.

Contact Info

Brand: NexiGo

Website: www.nexigo.com

Manufacturer: Nexight INC

Email: cs@nexigo.com

Tel: +1(458)215-6088

Address: 11075 SW 11th St, Beaverton, OR 97005, US

Product Introduction

The P-5 charging station is designed for P-5 DualSense controllers. It can charge up to two DualSense wireless controllers simultaneously without having to connect them to your P-5 console. You can charge your controllers quickly and easily with the charging station's type-c connectors. The charging lights are indicated in red and green to show controllers' battery status.

Product Diagram

Product Features

1. Intelligent micro control technology to prevent controllers from overcharge;
2. Charge up to two P-5 controllers simultaneously;
3. Type-C charging: insert connectors into the top of controllers to effectively protects the controllers from wear and tear;
4. Green and red lights indicate charging status;
5. Power saving mode once controllers are fully charged. Low power consumption mode when the dock is standby.

Charging Instruction

1. A 5V/2A wall charger is needed (not included).
2. Once the charging station is connected, the charging lights turn green.
3. Insert the Type-C adapters into the controllers, put them reversely on the dock for charging.
4. Red lights: in charge; Green Lights: fully charged.

NOTICE

• When the battery level of the controller reaches above 80% or more, if you remove the controller and put it back, the controller will not be charged due to the battery protection function. The dock will continue to charge only after the battery level of the controller drops below 80%.
• A 5V/2A power adapter should be used as a power source. The charging station will not work if the input power is insufficient.
• If the USB interface of the console is used and the electric current is less than 2A, the charging may be failed due to insufficient power. Note: only front USB ports of the console have enough power.

Specifications

Attentions

1. The power adapter should be unplugged when the controller is fully charged or the station is not in use for a long time.
2. This product cannot be used and stored in a humid environment.
3. This product should be kept out from dusts and heavy loads to reach maximum life-cycle.
4. Please do not use the product when is soaked, crashed, or damaged.