Table of Contents
Advertisement
Quick Links
CAUTION!
This manual contains important information for the correct installation, operation and maintenance of the equipment
described herein. All persons involved in such installation, operation, and maintenance should be thoroughly familiar with
the contents. To safeguard against the possibility of personal injury or property damage, follow the recommendations and
instructions of this manual and keep it for further reference.
WARNING!
The equipment shown in this manual is intended for industrial use only and should not be used to lift, support, or otherwise
transport people unless authorized in writing by Duff-Norton.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Duff-Norton TracMaster TMD01-1406
Summary of Contents for Duff-Norton TracMaster TMD01-1406
- Page 1 WARNING! The equipment shown in this manual is intended for industrial use only and should not be used to lift, support, or otherwise transport people unless authorized in writing by Duff-Norton.
-
Page 2: Table Of Contents
Duff-Norton® electromechanical support, or otherwise transport people unless the actuators. All persons operating or maintaining application is authorized in writing by Duff-Norton. these actuators should be familiar with the informa- tion presented here. The actuator can be used outdoors but must not be subjected to precipitation, high pressure sprays, icing, or submersion. -
Page 3: Specifications
1-3 Specifications Stroke Lengths: 2, 4, 6, 8, 10, & 12 inch. Special lengths on application. Duty Cycle: 25% max. on time at rated load and 25˚C ambient. Input Power: 12 or 24 VDC, depending on model. Ambient Temperature: -20˚F to 120˚F (-29˚C to 50˚C) Motor Protection: External fusing by installer recommended;... -
Page 4: Wiring Diagram (Limit Switch Models)
TracMaster 100 Performance Charts Load vs. Duty Cycle Speed vs. Load Speed Amp Draw vs. Load (12 & 24 VDC) (mm/min) in/min Amps (2032) (1778) (1524) (1270) (1016) (762) (508) 25 lbs 50 lbs 100 lbs 150 lbs 25 lbs 50 lbs 100 lbs 150 lbs... -
Page 5: Installation
1. Either 12 or 24 volts DC, to match the voltage rat- 2-1 Direction of Loading ing of the actuator, should be connected to the two Duff-Norton electromechanical actuators terminals of the relay board which do not have other can be used in tension, compression, or combination tension/compression applica- connections (see wiring diagram). - Page 6 DUFF-NORTON ELECTROM ECHANICAL ACTUATOR LIM ITATION OF WARRANTIES, REM EDIES AND DAM AGES The warranty stated below is given in place of all other warranties, express or implied, of merchantability, fitness for a particular purpose or otherwise. No promise or affirmation of fact made by any agent or representative of seller shall constitute a warranty by seller or give rise to any liability or obligation.
Need help?
Do you have a question about the TracMaster TMD01-1406 and is the answer not in the manual?
Questions and answers