Display - Dell INSPIRON Inspiron 9100 Owner's Manual

Lift the center hinge cover on the right side first just enough to access the
d
flex-cable connector.
Using the pull-tab, disconnect the center-hinge-cover flex cable from the system
e
board connector.
system board connector

Display

CAUTION:
Before you perform the following procedures, read and follow the safety instructions at the
front of this document (see page 9).
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by
periodically touching a connector on the back panel of the computer.
NOTICE:
To avoid damaging the system board, you must remove the main battery before you begin
working inside the computer.
center-hinge-cover
flex cable and pull-tab
Adding and Replacing Parts
center hinge
cover
115