PowerA GALACTIC VORTEX User Manual page 5

CHARGING
1 . Connect the provided USB cable to the
Nintendo Switch dock and the USB-C end to
the wireless controller .
2 . The Recharge LED by the USB-C port of the
controller will light up red while charging
and green when fully charged .
NOTE:
• Charge your controller at least once every 45–60 days (regardless of use) so that the battery retains its ability
to charge. Battery capacity will gradually reduce over time with repeated charging.
• When the battery is near depletion the Recharge LED will blink red and the Lumectra lighting will dim.
5
ADVANCED GAMING BUTTONS
PROGRAMMING
1 . Hold the Program Button down for 3 seconds . The Lumectra
lighting will slowly blink in white, signaling the controller is
in program mode .
2 . Press one of the following buttons (A/B/X/Y/L/R/ZL/ZR/
Left Stick Press/Right Stick Press/+Control Pad) you wish to
assign to an Advanced Gaming Button . The Lumectra lighting
will blink quickly .
3 . Press the Advanced Gaming Button (AGR or AGL) that you wish
to perform that function . The Lumectra lighting on the side
of the selected advanced gaming button will blink 3 times,
signaling the Advanced Gaming Button has been assigned .
4 . Repeat for the remaining Advanced Gaming Button .
NOTE: Advanced Gaming Button assignments will remain in memory even after your controller is disconnected .
RESETTING
1 . Hold the program button down for 2 – 3 seconds . The Lumectra lighting will slowly flash, signaling the
controller is in program mode .
2 . Press either AGL or AGR to individually reset each button or hold down the Program Button for 5 seconds to
reset both simultaneously .