Backyard Creations 272-2276 Manual

Step 1: Carefully unpack and identify all parts packed in
the carton against the parts list. Remove all
protective materials. If you are missing any parts
or are unsure how to proceed with assembly, call
our customer service center immediately at
1-800-416-3511. Do not attempt to assemble
glider if any parts are missing or damaged.
Assemble furniture on a smooth, non-abrasive
surface.
Step 2: Attach the back frame to the
1/4" x35mm bolt and washer as shown in s s
Guide the bolt through s the hole in
the pre-drilled hole in the s back frame. Hand tighten
only 2-3 turns .
B
I
A
F
H
Figure 1
Step 3: Attach the
1/4"
Guide
the
only
by using
in
seat frame
Hand tighten only
arm.
seat frame by using three
F igure 1
.
s the seat frame into
Step 4: Using
bolts. Do not over tighten bolts.
with
IMPORTANT NOTE: Damage to welds or frames
resulting from over tightened bolts or improper
assembly is not covered under our warranty. Please
read all instructions carefully before assembly. If
you have any questions regarding your assembly,
call our Customer Service Center at 1-800-416-3511.
back frame to the left arm by using
x40mm bolt and washer as shown in s s
the bolt through s the hole in s the back frame
pre-drilled hole in the s left arm. Hand tighten
2-3 turns Attach the . seat frame to the
two 1/4" x30mm bolt and washer as shown s
F igure 2
. Guide the bolt through s the
into the pre-drilled hole in the s
. Repeat for the other
2-3 turns
FOOT CAP I
G
H
E
I
D
Figure 2
the hex bolt driver provided , tighten all
Cover all bolts
bolt covers.
Page 2
* NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE
two
F igure 2
PARTS LIST
.
into
A
left arm
s
B
hole in s the
left arm.
C
D
E
F
G
H
Ø6.5 X 1.0 MM WASHER
H
I
C
J
FACTORY ASSEMBLY
DESCRIPTION ORDER PART # QTY
BACK FRAME SK1672 1
1
SEAT FRAME SK1673
1
LEFT ARM SK1674
RIGHT ARM SK1675 1
4
1/4" X 30 MM BOLT HW0038
3
1/4" X 35 MM BOLT HW0142
1/4" X 40 MM BOLT HW0086 4
11
HW0004
11
BOLT COVER HW0105
1
HEX BOLT DRIVER HW0006
FOOT CAP
FC0612
BGR00705K02