Advertisement
Quick Links
Advertisement
Related Manuals for Backyard Creations 272-3265
Summary of Contents for Backyard Creations 272-3265
- Page 1 HANGING LOUNGER 272-3265 Instruction Manual...
- Page 2 Assembly Instructions for Hanging Lounger, Model # 4717RB, SKU 272-3265 Thank you for purchasing the Hanging Lounger. We hope it provides years of enjoyment. Please read and follow the assembly and safety instructions for proper assembly and safe use of this product. If you are missing parts or if there are damaged parts, please call our customer service department at 800-295-6758 or, email sales@algomanet.com...
- Page 3 Parts P : One 3 ½” 16mm double threaded bolt with two 16mm washers and 2 acorn nuts. HARDWARE Parts Q : Two 2 ¾” x 13mm bolts with two 13 mm lock nuts and four 13mm washers. Parts R : One 3 ¾” x 13mm bolt with one 13 mm lock nut and two 13 mm washers. Parts S: Six plastic bolt caps Part T: Threaded connecting link.
- Page 4 Step 1: Locate Part A and Part B. Connect Part B to Part A by inserting end of Part B onto swedge end of Part A aligning holes as shown in (Diagram 1). Place a 13mm washer onto Part Q (2 ¾” Bolt) and insert through both Part A &...
- Page 5 Step 4: Locate Parts Y. Insert square nut into nut slot on bottom of O-ring of Part H, as shown in Box 7. Then insert hand knob of part Y through the hole of part H as in Box 8. Straighten the Part H assembly so the hand knob is just below the hanging hook as shown in Box 9, then tighten hand knob so Part H stays in place.
- Page 6 Step 7: Locate Parts R (3 ¾” Bolt with 13mm washer) and insert through one of Parts E. Place Part U (Closed S-Hook) onto the bolt Part R as shown in Box 13. Place the second and opposite Part E onto the bolt Part U as shown in Box 14. Place 13 mm washer and 13mm lock nut onto end of Part R and tighten using open ended wrenches (Part Z) as shown in Box 15.
- Page 7 Step 10: Locate Part F. Insert ends of Part F onto swedge ends of both Parts G as shown in Box 19, by pushing down lock- pins as in Box 20 until pins are fully engaged in lock holes as shown in Box 21. Part G Part F Box 20...
- Page 8 Step 13: Locate Part M and place inside seat frame as shown in Box 25. Next, locate black rope (Part K) and attach Part M to seat frame by first threading rope through the middle grommet of Part M and pulling half of the rope through the grommet. Lace Part M with rope over frame and through each grommet working from base on each side until the two rope ends meet at top brace (Part I) as shown in Box 26.
-
Page 9: For Your Safety
Step 16: Place the plastic protective caps (Part S) over the heads and the nuts on the chair frame as shown in photo. CONGRATULATIONS! Your Hanging Lounger is now complete. FOR YOUR SAFETY • Please always follow the safety instruction and use common sense when using the Hanging Lounger.