Gator SRX SOFT ROLL-UP TONNEAU COVER Installation Sheet

NOTE: It is important that all
areas where the bed cover
mounts are clean and free of
debris prior to installing.
PARTS INCLUDED
IN YOUR KIT
A Driver side rail
B Passenger side rail
Cover assembly
C
D 6x clamps
2x Hex nuts
E
2x Plastic washers
F
G 2x Tension adjustment blocks
H
2x Hitch pins
I
1x Weather seal pack
J
2x Bolts
1
The serial number for the cover is located here.
For future reference, write it here:
_________________________________________________
3
NOTE: The trigger latch is included on the driver side rail only.
Gator • 2303 SE 17th St, Ocala, Florida 34471 • 855-427-4568 ©Gator, 2024
D E
Position the driver side
rail (A) against the truck
bed rail. With the tailgate
closed, slide the rail
back until the rear seal
is slightly compressed
against the tailgate.
Adjust the rail vertically
so that the seal is flush
with the truck bed caps.
SRX SOFT ROLL-UP TONNEAU
COVER INSTALLATION SHEET
Any damaged or missing parts?
Parts will be shipped to you directly.
Call 855-427-4568, Mon - Fri, 8:00 a.m.- 9:00 p.m. EST,
Sat 9:00 a.m. - 8:00 p.m. EST.
F G
Passenger Pin
2
Peel and stick the foam weather seals (I) to each end
of the driver and passenger side rails (A & B).
4
Attach clamps (D) starting in the middle. Evenly space 3
clamps along the driver side rail (A), leaving approximately
8" on each end. Finger tighten to make sure the teeth
of the clamp engage with the grooves of the side rail.
Then tighten all clamps with a 1/2" socket or wrench.
NOTE: The use of spring clamps to hold the side rail in
place can assist during the installation process.
TOOLS REQUIRED
•
9/16" wrench or socket
•
1/2" wrench or socket
TOOLS RECOMMENDED
•
Spring clamps
Driver Pin
H
I
Part# 1117934 Rev J Rev. 6.25.2024
J