Download Print this page

Cornelius LOOP Pro Installation And Service Manual page 5

Overcounter cooler

Advertisement

1
Safety
1.1
Intended use
By using the unit as intended you will not only protect yourself, but also prevent damage occurring to the unit and its components!
You can find further information about the intended use of the unit in the overcounter cooler operator manual, document no.
TD1019000.
1.2
Improper use
Improper use of the unit and unauthorised modifications to the unit and its components may cause personal injury and equipment
damage for which Cornelius Deutschland GmbH shall assume no liability. Improper use of the unit is prohibited.
You can find further information about the improper use of the unit – and the meaning of improper use – in the overcounter cooler
operator manual, document no. TD1019000.
1.3
Staff
There is a clear definition as to what group of people is permitted to carry out what type of work on the unit. You can find further
information about who is authorised to carry out what type of work on the unit in the overcounter cooler operator manual, document
no. TD1019000.
1.4
Presentation of warnings
The documents supplied with the unit provide warnings regarding any dangers or hazards that might exist. You can find more
information about the design and presentation of warnings in the overcounter cooler operator manual, document no. TD1019000.
1.5
Safety information
1.5.1
Safety information to prevent personal injury and equipment damage
Any work on the unit and its components which goes beyond operation and beyond the servicing and maintenance tasks that the
operator is authorised for, may only be performed by experts (for a definition of experts, see the overcounter cooler operator
manual, document no. TD1019000). Furthermore, it is crucial that when performing work on the unit all safety information is
observed; this information is set out in the following sections. Some of the tasks may have additional safety information which
highlights the specific dangers or hazards associated with such work.
1.5.2
Safety information for using electrical assemblies
DANGER!
To prevent risks to health and safety, please always observe the following five safety rules:
These five safety rules are to be applied before carrying out work on the electrical system and in the order stated
below. Once work is completed, the safety rules are to be undone again in reverse order.
1. Disconnect from power.
2. Secure against reconnection.
3. Check that the system is disconnected from power.
4. Ground and short-circuit the system.
5. Cover or separate adjacent live parts.
WARNING!
Risk of burns when touching hot parts of the unit!
Touching parts of the unit after it has been in continuous use over an extended period of time will result in a risk
of burns.
Take appropriate safeguard measures, such as by wearing heat-resistant protective gloves.
DANGER!
Risk of poisoning and risk of explosion due to improper handling of CO
Risk of death from CO
Observe all information on occupational safety for the safe operation of dispensing systems as applicable
in the relevant country of installation.
NOTICE!
Make sure that the cable markers are not removed from the cables and/or mark or label the cables such
that they can be correctly assigned during installation.
Cornelius Deutschland GmbH
Document no.: TD1019100
Version 21/05/2021, Index 1
!
2
cylinders!
2
Installation and service manual Overcounter cooler
Safety
LOOP Pro
3

Advertisement

loading
Need help?

Need help?

Do you have a question about the LOOP Pro and is the answer not in the manual?