Aligning The Appliance - BALAY 3TS872BE Operating Instructions And Installation

Installing the unit

Aligning the appliance

The appliance must be placed on a firm flat surface to ensure that it
is stable during spinning.
Soft floor coverings, such as carpets or foam-backed flooring are
not suitable surfaces for installation.
! If you have a wooden joist floor, the appliance must be placed
on a water-resistant wooden board, 30 mm thick.
It must be screwed to the floor. The appliance should be
installed in a corner of the room if possible.
Securethe appliance to the floor using fastening brackets fitted
to the machine's feet (especially if the machine is a combined
washer/dryer).
! If the machine is placed on a pedestal or raised base, the feet
must be fixed using brackets to prevent the machine from
shifting during the spin cycle.
The fastening brackets are available as a spare parts set from your
specialist distributor.
! The appliance must sit firmly and horizontally on the four feet
without rocking.
m Use a spirit level to ensure that all four sides of the appliance are
level.
Correct any imbalance by adjusting the height of the feet.
m Loosen the locknuts.
m Adjust the height of the feet.
m Tighten the locknuts securely so that the height set is retained.
7
en