Larson Electronics EPL-BS-70LED-100-GAP Instruction Manual

Portable Explosion Proof LED Light Gen App Plug
Thank you for your purchase of the Larson Electronics EPL-BS-70LED Portable Explosion Proof LED Light.
Please follow the steps below in order to operate and maintain this product.
IMPORTANT
READ CAREFULLY BEFORE OPERATING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR
REFERENCE. THE EPL-BS-70LED MUST BE OPERATED IN ACCORDANCE WITH NATIONAL ELECTRICAL CODE
AND ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.
FOR PERSONAL SAFETY, ALWAYS CONFIRM THE RATING OF ANY KNOWN HAZARDOUS OR POTENTIALLY
HAZARDOUS LOCATION WHERE THE LIGHT IS TO BE USED.
WARNING:
TO PREVENT IGNITION OF A HAZARDOUS ATMOSPHERE, THE SUPPLY CIRCUIT SHOULD BE
DISCONNECTED WHEN INSTALLING OR PERFORMING ANY MAINTENANCE ON THIS UNIT.
WARNING:
WHEN INSTALLING THIS
TEMPERATURE LIMITS PRIOR TO INSTALLATION TO BE SURE IT CONFIRMS TO THE ENVIRONMENTAL
TEMPERATURE RESTRICTIONS AND NEC CLASSIFICATIONS. CHECK THE FIXTURE'S METAL NAMEPLATE FOR
TEMPERATURE (T) RATINGS.
WARNING:
DO NOT SCRATCH OR CHIP THE FRONT LENS. TURN THE POW ER OFF BEFORE STARTING
INSTALLATION OR REPAIR.
WARNING:
OPERATE THIS FIXTURE ONLY AT THE VOLTAGE OF YOUR SPECIFIC SUPPLY CIRCUIT. FAILURE
TO DO SO WILL RESULT IN DAMAGE TO THE FIXTURE.
WARNING:
SUBSTITUTE COMPONENTS MAY IMPAIR EXPLOSION PROOF SAFETY.
OPERATING
Before operation, confirm that the power source will provide the correct voltage indicated on the product
nameplate. Ensure the receptacle will accept the cord cap attached to the light.
Check product nameplate for Ratings and Approvals.
Place the light in the desired location and run its power cord to a power source outside the hazardous area!
Ensure all safety requirements are followed within the hazardous area.
This light is "instant-on" and will illuminate once power is supplied.
MAINTENANCE
It is recommended that you implement a standard monthly or more frequent preventive maintenance schedule.
Safety requires a thorough visual examination of the unit for physical damage that might cause a spark or
result in the ignition of hazardous atmospheres.
Maintenance includes a careful examination to ensure at least:
A.
The Light Body is not cracked, broken or breeched.
B.
The Lens is not cracked or chipped.
C.
The Cable is not frayed and is gripping tightly in all points of cable contact.
Larson Electronics, LLC
EPL-BS-70LED-100-GAP Instruction Guide
LIGHT IN HAZARDOUS
Phone: (800) 369-6671
LOCATIONS, CHECK
Fax: (903) 498-3364
EPL-BS-70LED-100-GAP
THE OPERATING
www.larsonelectronics.com
FUTURE
1 of 2