Larson Electronics EXHL-TRN-ZN-LE9-FKLT-RED Instruction Manual

Pedestrian Safety - Red - 10-100V DC - ATEX/IECEX
Do not attempt installation until you are familiar with all warnings, precautions, and procedures outlined within
this instruction sheet.
WARNING:
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE
REFERENCE. CRITICAL SAFETY INSTRUCTIONS:
•
To avoid the risk of fire, explosion, or electric shock, this product should be installed, inspected, and
maintained by a qualified electrician only, in accordance with all applicable electrical codes.
To avoid electric shock:
•
Be certain electrical power is OFF before and during installation and maintenance.
•
Luminaire must be supplied by a wiring system with an equipment grounding conductor.
To avoid burning hands:
•
Make sure lens and housing are cool when performing maintenance.
To avoid explosion:
•
Make sure the supply voltage is the same as the luminaire voltage.
•
Do not install where the marked operating temperatures exceed the ignition temperature of the
hazardous atmosphere.
•
Do not operate in ambient temperatures above those indicated on the luminaire nameplate.
•
Use proper supply wiring as specified on the luminaire nameplate.
•
All gasket seals must be clean.
•
Before opening, electrical power to the luminaire must be turned off. Keep tightly closed when in
operation.
•
Use only UL listed components suitable for Class I Division 1, Groups C & D and Class II Division 1,
Groups F & G installation.
•
All threaded connections must engage five full threads.
Refer to the luminaire nameplate for specific
classification information, maximum ambient
temperature suitability, and corresponding operating
temperature (TCode).
MOUNTING & WIRING
1. Mount the enclosure to surface in a location
that can support the load. Use single bolt to
provide rotation when mounting.
2. Loosen the two set screws on the bracket to
adjust vertical position as necessary.
Voltage: 10-100V DC
Larson Electronics, LLC
27W Explosion Proof Forklift LED Zone Light
Instruction Manual
Phone: (800) 369-6671
WIRING
1. Remove the front cover module by rotating
counter-clockwise.
2. Pull field wiring into module.
3. Close all unused conduit entries with conduit
plugs. To ensure water-tightness, lubricate
conduit plugs with lubricant before installing,
and secure wrench-tight with at least five (5)
full threads engaged (42-52 ft.-lb. for 3/4"
plugs, and 58-68 ft.-lb. for 1" plugs).
4. Connect supply wires to luminaire wire leads
(or terminal blocks) using methods that comply
with all applicable codes. Tighten all electrical
connections.
5. Close cover module, making sure that all wires
are safely inside driver.
6. Turn power on and aim light.
Fax: (903) 498-3364
EXHL-TRN-ZN-LE9-FKLT-RED
www.larsonelectronics.com 1 of 2