Magura HYDRAULIC BRAKE Manual page 12

w w w . m a g u r a . c o m
s e r v i c e @ m a g u r a . d e
7. Put the hose on a hard surface. Cut the hose squarely just behind the olive using a
cutter, never use pliers or a saw.
The olive must be replaced! Hold the hose carefully so that it cannot spring
away! Cut squarely and on a hard surface to achieve a clean cut. Never use
pliers or a saw! Throw away the hose piece with the fitted olive. Slide off the sleeve nut.
Slide the hose carefully through the heatshrink tube. Measure the correct length of the
hose (don't forget to turn the handlebars!) and cut the tubing as described.
8. Slide the sleeve nut and a new olive on the hose. When you use the formerly
used, brass colored olives, the grooved side (arrow) points toward the sleeve nut.
9. The black olive cannot be mounted incorrectly, as it is symetrical. Push the hose
all the way into the slave cylinder.
10. Do not crossthread! After initial start by hand use an 8mm open end wrench.
(Tightening torque 4Nm/34 in.lbs).
11. Always check for correct installation by pulling on the hose Make sure
that the system has no leaks by activating the levers and checking all connec-
tions.
12. Use an extra piece of heatshrink tube which you slide over the exposed end of
the carrier cable. Shrink the heatshrink tube over its entire length with a hairdryer.
Only use a hairdryer! Never use a lighter or a heatgun. Protect your frame
and decals with carton before.
12