Shark PowerDetect IP1000 Series Owner's Manual page 25

CHARGING YOUR LI-ION BATTERY
BATTERY REMOVAL
To remove the battery from the vacuum,
press the release button on the battery
and slide out of the handle compartment�
To reinstall, slide the Battery back into the
compartment until it clicks into place�
NOTE: The main unit comes with a partial charge� For maximum runtime, charge fully before first use (approximately 6
hours)� Leaving the unit plugged in will not damage battery life�
8
sha rkclean.eu
CHARGING SLEEVE
To charge the battery, remove it from the
vacuum and insert into the charging sleeve�
Once the battery is showing as fully charged
reinsert into the handle compartment on the
vacuum (see charging indicators on previous
page)
USING YOUR VACUUM
CONTROLS AND CLEANING MODES
POWER
Press the button on the UI Screen to
turn on power� To turn off power, press the
button again�
UPRIGHT LOCK
To begin cleaning with the floor nozzle,
disengage the lock by stepping on the nozzle
and tilting the hand vac down�
NOTE: For - Best Cleaning on ASTM and IEC Cleaning Tests, Use Boost Mode�
MODE SELECT
To toggle between ECO, DETECT, and
BOOST modes, press the mode selection
trigger on the handle (shown above)�
In DETECT mode, Detect Technology
automatically adjusts vacuum and nozzle
power to maximise cleaning performance
and optimise runtime�
s ha rkc l ea n.eu
9