Reece posh Solus All Door 600 Installation Instructions

Solus All Door 600 Floor & Wall Mounted Vanity Unit
Check
Prior to installation it is important to unpack & inspect your products to ensure no
damage has occurred in transit and that the product IS CORRECT. If damage has
occurred, or a visible defect exists, do not proceed with
installation and contact supplier IMMEDIATELY.
Installation Instructions
1. Check that wall is level and plumb both vertically and horizontally. If your wall is out of plumb, or is not flat, you will
need to pack your vanity so as not to follow the wall. Your vanity must be level, otherwise it will twist and your doors
and drawers will be out of alignment.
2. Mark base and back of vanity for drilling to allow for plumbing pipes.
3. Drill holes for pipes with appropriate size hole saw.
4. Position vanity over pipes in correct position. It may be an idea to use a level support / noggin to assist in levelling a
wall hung unit and help identify any un-plumb surfaces which may require packing prior to fixing the unit to the wall.
5. Check with spirit level that the vanity unit is completely level.
6. Fix vanity to wall through back of vanity ensuring the correct screw/dynabolt size is used by the installer to suit the
installation situation.
Where studs cannot be located, it is recommended to use toggle bolts or appropriate hollow-wall fixings. Allow
enough fixing points, evenly spaced at the top AND bottom of the back panel, to sufficiently hold the particular unit
size onto the situation of the installation area. It may be handy to apply some silicone/adhesive to the rear of the unit
prior to fixing, this may assist in levelling and fixing the unit to the wall.
7. Adjust doors and drawers if required as there may have been some movement during transportation and installation.
(refer instructions included in unit)
8. Once vanity cabinet is in final position affix vanity top onto cabinet by applying thin bead of silicone on top edge of
vanity. Evenly place vanity top onto vanity and firmly press down. Clean of any excess sealant.
9. All edges where vanity top and cabinet meet wall and floor are to be sealed with silicone. Gap filler sealant can be
used in place of silicone where unit meets tiled surfaces. All areas need to be sealed to prevent water penetration.
Materials used for construction of this unit are water resistant NOT water proof. Care must be taken to dry any
spillage or leakage of water which may gain access to cabinet. It is recommended that vanities are installed over
300mm from any wet areas such as baths, spas and showers.
Mizu - Solus All Door 600 Floor & Wall Mounted Vanity Unit Page 01 of 04