APRILIA SL MILLE - PART 3 1999 Manual page 26

Hide thumbs Also See for SL MILLE - PART 3 1999:
Table of Contents

Advertisement

Carefully read p. 75 (BATTERY).
CAUTION
Do not remove the battery plugs: with-
out plugs the battery may be damaged.
N
Remove the battery, see p. 76 (REMOV-
ING THE BATTERY).
N
Prepare an appropriate battery charger.
N
Set the charger for the desired type of re-
charge (see table)
N
Connect the battery with a battery charg-
er.
WARNING
During the recharging or the use, make
sure that the room is properly ventilated
and avoid inhaling the gases released
during the recharging.
N
Switch on the battery charger.
Voltage
Recharge
(amp)
Normal
1.2
Quick
12
WARNING
Reassemble the battery only 5/10 min-
utes after disconnecting the recharge
apparatus, since the battery continues
to produce gas for a short lapse of time.
Carefully read p. 75 (BATTERY).
N
Make sure that the ignition switch is in
m
position "
N
Remove the rider saddle, see p. 66 (RE-
MOVING THE RIDER SADDLE).
NOTE
The battery (1) must be posi-
tioned in its compartment with the termi-
Time
nals facing upwards.
(hours)
N
8 – 10
Put the battery (1) in its compartment.
0.5
NOTE
Upon reassembly of the battery
cover (2), correctly insert the two lower
tangs in the appropriate seats; connectors
and electric cables must be positioned in
such a way as to avoid any crushing.
".
N
Put back the battery cover.
N
Put back the bracket (3) that locks the bat-
tery.
N
Screw and tighten the screw (4).
WARNING
Upon reassembly, connect first the pos-
itive cable (+) and then the negative ca-
ble (–).
N
Connect the positive terminal (+) by
means of the screw (5).
N
Connect the negative terminal (–) by
means of the screw (6).
N
Put back the red protection element (7).
use and maintenance SL mille
77

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sl mille

Table of Contents