Table of Contents
Advertisement
N
Position the vehicle on the side stand on
firm and level ground.
#
N
Partially raise the rear side edge of the
saddle.
#
N
Unscrew and remove the screw (1)
and take the bushing (2).
Screw (1) driving torque:
12 Nm (1.2 kgm).
N
Raise and remove the saddle (3).
NOTE
Upon reassembly, insert the front
tang of the saddle in the appropriate seat.
CAUTION
Before leaving, make sure that the sad-
dle (3) is properly positioned and locked.
66
use and maintenance SL mille
Carefully read p. 30 (FUEL) and p. 51
(MAINTENANCE).
WARNING
Risk of fire.
Wait until the engine and the exhaust si-
lencer have completely cooled down.
Fuel vapours are noxious for your
health.
Before proceeding, make sure that the
room in which you are working is prop-
erly ventilated.
Do not inhale fuel vapours.
Do not smoke and do not use naked
flames.
DO NOT DISPOSE OF FUEL IN THE EN-
VIRONMENT.
N
Remove the passenger seat, see p. 27
(UNLOCKING / LOCKING THE PAS-
SENGER SEAT).
N
Remove the rider saddle, see beside
(REMOVING THE RIDER SADDLE).
N
Turn the handlebar in such a way as to
position the front wheel straight, in the
travel direction.
N
Unscrew and remove the two screws (4)
that fasten the front part of the fuel tank
(5).
N
Remove the fuel tank support rod (8)
from the relevant anchorage seats (6-7).
NOTE
The rubber-covered end of the
stick (8) must be introduced in the central
hole of the steering pin.
N
Lift the front part of the fuel tank (5) and
introduce the rod (8) as indicated in the
figure.
Advertisement
Table of Contents
