Subscribe to Our Youtube Channel
Related Manuals for Smithco SPRAY STAR 1110
Summary of Contents for Smithco SPRAY STAR 1110
- Page 1 Operator’s Manual SPRAY STAR 1110 1101 Manual System 1102 Radion 8140 1104 TeeJet 744 1105/1108 Star Command I 1115/1118 Star Command II Product Support: Hwy SS & Poplar Ave; Cameron WI 54822 1-800-891-9435 productsupport@smithco.com...
- Page 2 CONTENTS Introduction ..............1-10 Introduction ..............1 Symbols ..............2 Safety ................3 Safety Decals .............. 4 General Safe Practices ..........5 Safe Spraying Practices ..........6 Specifications ............. 7 Optional Spray Equipment .......... 7 Set Up ................. 8 Controls & Instruments ........... 9-10 Operation ..............
- Page 3 All Smithco machines have a Serial Number and Model Number. Both numbers are needed when ordering parts. The serial number plate on the Spray Star 1110 is located on the right hand frame rail. Refer to engine manual for placement of engine serial number. Refer to engine manual for placement of engine serial number.
- Page 4 Ground Speed Oil Level Park Brake Park Brake Slow Fast Lift Arm Release No Riders Hydraulic Fluid Hot Surface Moving Parts Pinch Point Penetration 20° MAX Rollover Warning Blower Headlamp Seat Belt Danger Danger Caution PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
- Page 5 It may also be used to alert against unsafe practices. IMPORTANT: Blue. Indicates procedures which should be followed to avoid damage to the machine. PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
- Page 6 New decals are available from your authorized distributor or factory. THIS IS A LIST OF DECALS LOCATED ON THE SPRAY STAR 1110. PART NUMBER, DESCRIPTION AND LOCATION WILL HELP IN REORDERING A DECALS.
- Page 7 These machines are intended for professional maintenance on golf courses, sports turf, and any other area maintained turf and related trails, paths and lots. No guarantee as to the suitability for any task is expressed or implied. PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
- Page 8 If using Simulated Speed with a Radion 8140, one needs to change back to Ground Speed for proper rate control when spraying. PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
- Page 9 Water Meter Kit 1101 3-Way Manual System 15-965 Foam Marker 1105/1108 DynaJet/Radion Spray System 15-622 Canopy 15-967 Hose Reel Mount Kit 16-129 Manual Rewind Hose Reel, 200-foot/61-meter capacity 16-906 Electric Rewind Hose Reel, 200-foot/61-meter capacity PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
- Page 10 6. Attach the Spray Boom and any other Optional Equipment to the Prime Mover, in accordance with in- structions in the Spray Star 1110 Parts/Service Manual. The nozzles must be the correct distance above the turf as described in Turf Spraying Guide. The spray boom must operate properly and the outer sec- tions must break away safely if an object is struck by them, they must then return to normal operation position.
- Page 11 0 mph. Pointer will stay at 0 mph and oscillate slightly at zero to indicate the GPS is acquiring satellites. GPS is not yet functional to indicate speed. Once satellites are acquired (15-45 seconds), the pointer will swing full scale and then back toward 0 mph to indicate it is now ready for operation. PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
- Page 12 It is used to override the master switch on the com- puter console of the Radion Spray Systems. By pushing down it will turn on/off the booms. For TeeJet Systems, the master switch on the computer must be on. PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
- Page 13 OPERATION Before operating the Spray Star 1110, become familiar with all controls and functions. Also complete all main- tenance requirements and read all safety warnings. Knowing the Spray Star 1110 thoroughly, how it operates, and by doing the prescribed maintenance steps, you can expect trouble free operation for years to come.
- Page 14 TOWING UNIT When it is necessary to move the Spray Star 1110 without the engine running, the bypass valve built into hydrostatic pump must be "open" by turning it counterclockwise. The valve is located on the bottom of the pump. An "open" valve allows fluid to pass through the wheels freely.
- Page 15 Hold one in place and turn the other wrench to loosen assembly. Once apart, clean with water and check for deteriorating parts. Replace parts as needed by ordering the Spare Parts Kit 20-673-01P. PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
- Page 16 Located to the right of the control panel. Use lever on compressor to designate which boom is to be used to dis- pense foam. Use dial located on the foamer to adjust pressure for the amount of foam that will be dispensed. Switch on compressor also turns foamer on or off. PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
- Page 17 WIRING DIAGRAM Color Code Chart Blue Brown Yellow Green Orange...
- Page 18 HYDRAULIC DIAGRAM...
- Page 19 Widna tal-Operatur ▪ Dopuszczalny poziom hałasu dla operatora ▪ Nível sonoro nos ouvidos do operador ▪ Nivelul zgomotului la urechea operatorului ▪ Hladina hluku pôsobiaca na sluch operátora ▪ Raven hrupa pri ušesu upravljavca ▪ Nivel sonoro en el oído del operador ▪ Ljudnivå vid förarens öra PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
- Page 20 Hyväksyntänumero ▪ Numéro de certificat ▪ Bescheinigungsnummer ▪ Αριθμός Πιστοποιητικού ▪ Hitelesítési szám ▪ Numero del certificato ▪ 10100-2021-1 Sertifikāta numurs ▪ Sertifikato numeris ▪ Numru taċ-Ċertifikat ▪ Numer certyfikatu ▪ Número do Certificado ▪ Număr certificat ▪ Číslo osvedčenia ▪ Številka certifikata ▪ Número de certificado ▪ Certifikatsnummer PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
- Page 21 NOTES PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
- Page 22 QUICK REFERENCE REPLACEMENT PARTS REPLACEMENT FILTERS 23-031 Hydraulic Oil Filter Element 25 Micron 13-531 Engine Oil Filter Briggs# 842921 10-575-02 Air Filter Briggs# 692519 10-575-03 Air Filter Pre-Cleaner Briggs# 692520 50-403 In-Line Fuel Filter REPLACEMENT BELTS 30-432 Belt (engine to Hypro® Pump) SEAL KITS 15-301 Orbital...
- Page 23 30 days from discovery of the condition. If you need help locating an Authorized Smithco Distributor, or if you have questions regarding your warranty rights or responsibilities, you may contact us at: Smithco Product Support Department 200 West Poplar Ave.
- Page 24 This warranty does not apply to normal “wear and tear” items. Normal “Wear and Tear” includes, but is not limited to, damage to seats due to wear or abrasion, worn painted surfaces, scratched decals or windows, etc. Smithco may require the return of failed parts or components in order to determine the validity of any warranty claim.
Need help?
Do you have a question about the SPRAY STAR 1110 and is the answer not in the manual?
Questions and answers