Related Manuals for Smithco Spray Star 1011
Summary of Contents for Smithco Spray Star 1011
- Page 1 Operator’s Spray Star 1011 SharpShooter w/ Raven 440 with 15’ Booms November 2015 Product Support: Hwy SS & Poplar Ave; Cameron WI 54822 1-800-891-9435 productsupport@smithco.com...
-
Page 2: Table Of Contents
CONTENTS Introduction..............1-11 Introduction ..............1 Symbols ..............2-3 Safety Decals ............4-5 General Safe Practices ..........6 Safe Spraying Practices ..........7 Specifications .............. 8 Optional Spray Equipment .......... 8 Set Up ................. 9 Controls & Instruments .........10-11 Operation ..............12-29 Operating Instructions .......... -
Page 3: Introduction
For easy access record your Serial and Model numbers here. Information needed when ordering replacement parts: 1. Model Number of machine. 2. Serial Number of machine. 3. Name and Part Number of part. 4. Quantity of parts. PARTS MANUALS AVAILABLE ONLINE AT smithco.com... -
Page 4: Symbols
Temperature Gasoline Diesel Glow Plug - On Glow Plug - Off Glow Plug Hour Meter Hour Meter Fuse Hand Throttle Choke - Closed Choke - Open Park Brake Hydraulic Oil Park Brake Release Level PARTS MANUALS AVAILABLE ONLINE AT smithco.com... - Page 5 Up/Down Arrow Down/Lower Up/Raise Manual No Smoking Moving Parts Operation Step Hot Surface Pinch Point Hydraulic Fluid Lift Arm Tractor Penetration Engage Disengage Ground Speed Fast Slow Forward High Warning Danger Reverse Neutral Caution PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
- Page 6 CAUTION: Yellow. Indicates a potentially hazardous situation that, if not avoided, may result in minor or moderate injury. It may also be used to alert against unsafe practices. PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
-
Page 7: Safety Decals
G 15-672 Decal, Dash Panel Dash Board 25-373 Decal, Smithco Front Nose Cone 27-077 Decal, Smithco Steering Wheel 10-414** Decal, Control Panel RH Control Panel 25-277** Decal, Battery Warning Seat Panel ** Safety Decals Required PARTS MANUALS AVAILABLE ONLINE AT smithco.com... -
Page 8: General Safe Practices
These machines are intended for professional maintenance on golf courses, sports turf, and any other area maintained turf and related trails, paths and lots. No guaranty as to the suitability for any task is expressed or implied. PARTS MANUALS AVAILABLE ONLINE AT smithco.com... -
Page 9: Safe Spraying Practices
19. TRANSPORT - Machine must be stopped to raise or lower booms. Because of cam system, if booms are raised in transit they can fall forward or backward when coming to a stop or while traveling on uneven terrain. PARTS MANUALS AVAILABLE ONLINE AT smithco.com... -
Page 10: Specifications
10-370 Water Meter Kit (liters) 30-141 26 Gal. Wash System 10-365 Water Meter Kit (gallons) 10-422 Hose Reel Mount Kit 16-129 Manual Rewind Hose Reel, 200-foot/61-meter capacity 16-906 Electric Rewind Hose Reel, 200-foot/61-meter capacity PARTS MANUALS AVAILABLE ONLINE AT smithco.com... -
Page 11: Setup
9. Read operating instructions before starting. Never allow pump to run dry! The valve on the suction side of the pump (between the pump and tank) must be fully open whenever the pump is operated. PARTS MANUALS AVAILABLE ONLINE AT smithco.com... -
Page 12: Controls & Instruments
L. Park Brake - The park brake is only a parking brake. Pull back to release, push forward to apply. Some adjustment can be made by turning the knob clock- wise to tighten and counter clockwise to loosen. PARTS MANUALS AVAILABLE ONLINE AT smithco.com... -
Page 13: Controls & Instruments
By pushing down it will turn on/off the booms. For the 440 System the Master Switch on the computer must be off for the master boom control switch to work. PARTS MANUALS AVAILABLE ONLINE AT smithco.com... -
Page 14: Operation
3. Remove the ignition key and engage the park brake. Never leave the vehicle unattended with the engine running. Always bring the vehicle to a complete stop, engage park brake, turn key off and remove key. PARTS MANUALS AVAILABLE ONLINE AT smithco.com... - Page 15 4. Connect other end of cable (D) to engine block on unit being started (NOT to negative (-) terminal of battery) To prevent damage to other electrical components on unit being started, make certain that engine is at idle speed before disconnecting jumper cables. PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
- Page 16 Envizio Pro II comes with a Quick Reference Guide and an Installation & Operation Manual. Please read these manuals before operation. Manuals can be downloaded off the internet at www.ravenprecision.com and off the www.smithco.com website under Parts and Technical Information. PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
-
Page 17: Sharpshooter-Raven 440 Console Features
RAVEN 440 WITH SHARPSHOOTER FEATURES Decrease Flow Increase Pressure Rocker Switch PSI/PWM PARTS MANUALS AVAILABLE ONLINE AT smithco.com... - Page 18 VALVE CAL Control Valve Response Time VOLUME/TANK Volume Remaining in Carrier Tank RATE 1 CAL Target Application Rate TIME 24 hour clock (military time) RATE 2 CAL Target Application Rate SELF TEST Simulates Vehicle Speed PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
-
Page 19: Console Programming
If the Distance display reads any other value, divide Speed Cal by the value observed in Distance, then multiply by 5280. This will give you the correct value to enter for Speed Cal. You must round off to the nearest 3 digit number (use 120 not 120.3). PARTS MANUALS AVAILABLE ONLINE AT smithco.com... - Page 20 Nozzle Charts Section, since it comes closest to providing the desired output. VERIFYING FLOW RATE LIMITS The flow rate of the sprayer must be within the range of 1 to 55 GPM (4 to 210 lit/min). PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
-
Page 21: Initial Programming
If there is only one boom, enter "0" for width of BOOM 2. 7. Enter width in inches (cm) of BOOM 3 in the key labeled: If there is only one or two boom, enter “0” for width of BOOM 3. PARTS MANUALS AVAILABLE ONLINE AT smithco.com... - Page 22 To “zero out” this total, at any time enter a “0” in this key. 5. To display DISTANCE (feet (meters) traveled) momentarily depress key labeled: To “zero out” this total, at any time, enter a “0” in this key. PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
- Page 23 5 seconds, OLD CODE message will appear. 2. Enter 4 digit OLD CODE within 15 seconds. EXAMPLE: depress NEW CODE message will appear. Enter 4 digit code within 15 seconds. EXAMPLE: For 1285, depress PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
- Page 24 3 = 10% + Deadband 7 = 35% + Deadband Actual rate is displayed if unit does not reach deadband with in 10 seconds. “doFF” means RATE displays ac- tual rate at all times. PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
-
Page 25: Initial Programming
11. Hold the MAN ADJ switch in DECR position for approximately 12 seconds. This assures motorized control valve is fully closed. Verify minimum pressure and RATE can be achieved. If not, consider bypass plumb- ing system in Appendix 3. PARTS MANUALS AVAILABLE ONLINE AT smithco.com... -
Page 26: Spray Operation
Located to the right of the control panel. Use lever on compressor to designate which boom is to be used to dispense foam. Use dial located on the foamer to adjust pressure for the amount of foam that will be dispensed. Switch on compressor also turns foamer on or off. PARTS MANUALS AVAILABLE ONLINE AT smithco.com... -
Page 27: Re-Calibration Of Flow Meter
This section is intended to offer practical guidelines for the distribution of liquid chemicals over an area of turf grass such as golf courses, park land, school grounds and lawns. SMITHCO makes no representation as to the suitability of any technique or product for any particular situation. This section is suitable for self-propelled spray vehicles or sprayers mounted onto vehicles. -
Page 28: Turf Management
" (1.25 cm) inside diameter hose is adequate. Trees over 40 ft (12 m) high re- quire " (2 cm) inside diameter hose and a sprayer pump capable of delivering a volume of at least 20 gpm (75 lpm) and a pressure of at least 400 psi (28 bar). PARTS MANUALS AVAILABLE ONLINE AT smithco.com... -
Page 29: Troubleshooting Nozzle Valves
O-ring 30-168-20P Valve Body 30-168-26P Flynut 30-168-25P Plunger 30-168-17P O-ring 30-168-19P Coil 30-168-21P Complete Nozzle Valve Assembly 30-168-05P The nozzle valve assembly (30-168-05P) screws into the nozzle bodies replacing the standard diaphragm check valve. PARTS MANUALS AVAILABLE ONLINE AT smithco.com... - Page 30 The result is erratic pulsing, often described as “flicker- ing.” SharpShooter will operate normally at lower pres- sures until replacement parts can be acquired. High oper- ating pressures and abrasive spray solutions will accelerate the wear of the plunger seal material. PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
- Page 31 204 0.454545455 27.27272727 457.6 204 0.445804196 26.74825175 466.4 204 0.437392796 26.24356775 475.2 204 0.429292929 25.75757576 204 0.421487603 25.2892562 492.8 204 0.413961039 24.83766234 501.6 204 0.406698565 24.40191388 510.4 0.39968652 23.98119122 519.2 204 0.392912173 23.57473035 204 0.386363636 23.18181818 PARTS MANUALS AVAILABLE ONLINE AT smithco.com...
-
Page 32: Reference
2000/14/EÜ mõistes Direktiivin 2000/14/EY mukainen ilmoitettu tarkastuslaitos Isossa-Britanniassa Organisme notifié concernant la directive 2000/14/CE Britische benannte Stelle für 2000/14/EG 2000/14/ Smithco West Inc. 2000/14/EK – egyesült királyságbeli bejelentett szervezet Organismo Notificato in GB per 2000/14/CE 2000/14/EK AK re istr t organiz cija 200 West Poplar Avene... - Page 33 The place and date of the declaration Místo a datum prohlášení Sted og dato for erkl æringen Plaats en Smithco West Inc. datum van de verklaring Deklaratsiooni väljastamise koht ja kuupäev Vakuutuksen paikka ja päivämäärä Lieu et date de la déclaration 200 West Poplar Avenue Ort und Datum der Erklärung...
- Page 34 30 days from discovery of the condition. If you need help locating an Authorized Smithco Distributor, or if you have questions regarding your warranty rights or responsibilities, you may contact us at:...
- Page 35 This warranty does not apply to normal “wear and tear” items. Normal “Wear and Tear” includes, but is not lim- ited to, damage to seats due to wear or abrasion, worn painted surfaces, scratched decals or windows, etc. Smithco may require the return of failed parts or components in order to determine the validity of any warranty claim.
Need help?
Do you have a question about the Spray Star 1011 and is the answer not in the manual?
Questions and answers