Advertisement
To rapidly check the correct direction of the
beam, place the vehicle on flat ground, 10
m away from a wall.
Turn on the low beam, sit on the vehicle
and make sure that the beam projected on
the wall is slightly under the horizontal line
of the headlight (about 9/10th of the total
height).
To adjust the headlight beam:
N
Act on the suitable screw (1) by means
of a screwdriver.
By TURNING IT CLOCKWISE, you set
the beam upwards.
By TURNING IT ANTICLOCKWISE, you
set the beam downwards.
To adjust the headlight beam, proceed as
follows:
N
Loosen the nut (2).
N
Adjust the inclination of the headlight (3).
N
Tighten the nut (2).
N
Make sure that the nut (2) is tightened
correctly.
N
Make sure that the headlight (3) is direct-
ed correctly.
Carefully read p. 43 (MAINTENANCE)
WARNING
Risk of fire.
Keep fuel and other flammable sub-
stances away from the electrical com-
ponents.
CAUTION
Before changing a bulb, position the ve-
hicle on the centre stand, move the igni-
tion switch to position "
few minutes, so that the bulb cools
down.
Change the bulb wearing clean gloves
or using a clean and dry cloth.
Do not leave fingerprints on the bulb,
since these may cause its overheating
and consequent breakage.
If you touch the bulb with bare hands,
remove any fingerprint with alcohol, in
order to avoid any damage.
DO NOT FORCE THE ELECTRIC
CABLES.
use and maintenance Habana 50/125 - Habana Custom 50/125
" and wait a
67
Advertisement
