How To Use Multiple Static Public Wan Ip Addresses For Lan To Wan Traffic; Create The Public Ip Address Range Object - ZyXEL Communications ZYWALL USG 1000 - EDITION 2 Manual
Unified security gateway
Hide thumbs
Also See for ZYWALL USG 1000 - EDITION 2:
- User manual (1075 pages) ,
- Support notes (345 pages) ,
- Quick start manual (130 pages)
Table of Contents
Advertisement
Click Configuration > Firewall > Add. Set the From field as DMZ and the To
1
field as LAN. Set the Destination to the IPPBX's DMZ IP address object
(DMZ_SIP). Set the
and click OK.
Figure 117 Configuration > Firewall > Add
7.13 How to Use Multiple Static Public WAN IP
Addresses for LAN to WAN Traffic
If your ISP gave you a range of static public IP addresses, here is how to configure
a policy route to have the ZyWALL use them for traffic it sends out from the LAN.
7.13.1 Create the Public IP Address Range Object
Click Configuration > Object > Address > Add to create the address object
that represents the range of static public IP addresses. In this example you name
it Public-IPs and it goes from 1.1.1.10 to 1.1.1.17.
Figure 118 Creating the Public IP Address Range Object
ZyWALL USG 1000 User's Guide
to IPPBX_DMZ. Leave the Access field to allow
Source
Chapter 7 Tutorials
161
Advertisement
Table of Contents
Troubleshooting
