Setup A Nat Policy For The Ippbx - ZyXEL Communications ZYWALL USG 1000 - EDITION 2 Manual
Unified security gateway
Hide thumbs
Also See for ZYWALL USG 1000 - EDITION 2:
- User manual (1075 pages) ,
- Support notes (345 pages) ,
- Quick start manual (130 pages)
Table of Contents
Advertisement
Chapter 7 Tutorials
Create a host address object named IPPBX-Public for the public WAN IP address
2
1.1.1.2.
Figure 114 Creating the Public IP Address Object
7.12.3 Setup a NAT Policy for the IPPBX
Click Configuration > Network > NAT > Add.
• Configure a name for the rule (WAN-DMZ_IPPBX here).
• You want the IPPBX to receive calls from the WAN and also be able to send calls
to the WAN so you set the Classification to NAT 1:1.
• Set the Incoming Interface to ge2.
• Set the Original IP to the WAN address object (IPPBX-Public). If a domain
name is registered for IP address 1.1.1.2, users can use it to connect to for
making SIP calls.
• Set the Mapped IP to the IPPBX's DMZ IP address object (IPPBX-DMZ).
• Set the Port Mapping Type to Port, the Protocol Type to UDP and the
original and mapped ports to 5060.
• Keep Enable NAT Loopback selected to allow the LAN users to use the IPPBX
(see
NAT Loopback on page 393
158
for details).
ZyWALL USG 1000 User's Guide
Advertisement
Table of Contents
Troubleshooting
