Chapter 41 Addresses
Table 195 Configuration > Object > Address > Address > Edit (continued)
LABEL
Interface
OK
Cancel
41.3 Address Group Summary Screen
The Address Group screen provides a summary of all address groups. To access
this screen, click Configuration > Object > Address > Address Group. Click a
column's heading cell to sort the table entries by that column's criteria. Click the
heading cell again to reverse the sort order.
Figure 465 Configuration > Object > Address > Address Group
The following table describes the labels in this screen. See
719
for more information as well.
Table 196 Configuration > Object > Address > Address Group
LABEL
Add
Edit
Remove
Object
References
#
Name
Description
718
DESCRIPTION
If you selected INTERFACE IP, INTERFACE SUBNET, or INTERFACE
GATEWAY as the Address Type, use this field to select the interface of
the network that this address object represents.
Click OK to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving your changes.
DESCRIPTION
Click this to create a new entry.
Double-click an entry or select it and click Edit to be able to modify the
entry's settings.
To remove an entry, select it and click Remove. The ZyWALL confirms
you want to remove it before doing so.
Select an entry and click Object References to open a screen that
shows which settings use the entry. See
an example.
This field is a sequential value, and it is not associated with a specific
address group.
This field displays the name of each address group.
This field displays the description of each address group, if any.
Section 41.3.1 on page
Section 13.3.2 on page 291
ZyWALL USG 1000 User's Guide
for