ZyXEL Communications ZYWALL USG 1000 - EDITION 2 Manual page 837

settings, including from which zones SNMP can be used to access the ZyWALL. You
can also specify from which IP addresses the access can come.
Figure 544 Configuration > System > SNMP
The following table describes the labels in this screen.
Table 242 Configuration > System > SNMP
LABEL
Enable
Server Port
Get
Community
Set
Community
Trap
Community
Destination
Service
Control
ZyWALL USG 1000 User's Guide
DESCRIPTION
Select the check box to allow or disallow the computer with the IP
address that matches the IP address(es) in the Service Control table to
access the ZyWALL using this service.
You may change the server port number for a service if needed, however
you must use the same port number in order to use that service for
remote management.
Enter the Get Community, which is the password for the incoming Get
and GetNext requests from the management station. The default is
public and allows all requests.
Enter the Set community, which is the password for incoming Set
requests from the management station. The default is private and allows
all requests.
Type the trap community, which is the password sent with each trap to
the SNMP manager. The default is public and allows all requests.
Type the IP address of the station to send your SNMP traps to.
This specifies from which computers you can access which ZyWALL
zones.
Chapter 50 System
837