ZyXEL Communications ZYAIR G-162 User Manual page 51

LABEL
Transfer Rate Select a transmission speed from the drop-down list box. Options are Fully Auto
(default), 1 Mbps, 2 Mbps, 5.5 Mbps, 11 Mbps, 6 Mbps, 9 Mbps, 12 Mbps, 18 Mbps,
22 Mbps, 24 Mbps, 36 Mbps, 48 Mbps, 54 Mbps and 125 Mbps.
Select Fully Auto to allow your G-162 to operate at the maximum available transmission
rate. Otherwise, select a number based on your network environment.
Power Saving Power consumption is reduced (especially good for notebooks that use batteries) in
Mode power saving mode.
Select Enabled and then click Save to immediately cut wireless transmission to/from the
G-162. If the G-162 resides in a Windows 98 computer, it may also reboot. The G-162
remains in power saving mode until there is traffic to transmit or receive.
Otherwise, select Disabled.
OTIST (One- Select this check box to enable OTIST.
Touch Intelligent
Security
Technology)
Setup Key Enter the same setup key (of exactly eight ASCII characters) as the OTIST-enabled AP
or wireless router to which you want to associate. The default OTIST setup key is
"01234567".
Start Click Start to encrypt the wireless security data using the setup key and have the
OTIST-enabled AP set your G-162 to use the same wireless settings as the OTIST-
enabled AP or wireless router. You must also activate and start OTIST on the OTIST-
enabled AP at the same time.
The process takes about three minutes to complete.
Save Click Save to save the changes.
Adapter
Table 6-1 Adapter
If you change the OTIST setup key on the OTIST-enabled AP, you
must also make the same change here.
ZyXEL G-162 User's Guide
DESCRIPTION
6-5