JST YHT-2622 Operation Manual

OPERATION MANUAL
FOR
. We
link
today and
tomor~ow
. YHT-2622, YHT-2210
(HAND CRIMP TOOL FOR NON-INSULATED TERMINALS/SPLICES)
~~/t/t/t/t/l/l/l/l/t/l/l/l/t/t/././~~/~~/./~I~~Ll/l/~~/~~/~/l/~~/l/l/./l/~~/l/./l/l/././././l/l/t/t/t/l/t/t/t/t
handle
Tool Model No.
Applicable terminal/splice
...•
Applicable Wire Range
non-Insulated terminal
Non-Insulated Splice
(Butt-type, parallel-type)
mm 2
AWG#
YHT-2622 0.5
-
0.2 -0.5 24-20
1.25
1.25 0.25-1.65 23-15
YHT-2210
2 2 1.04-2.63 17-13
5.5 5.5
2.63-6.64 13-9
Proper Tool Selection Chart
Crimp Operation
(1) Squeeze handles until the ratchet releases and
handles open.
(2) Position a connector in the die, placing the silver
brazed seam of the terminal on the center of the
~
die, (punch).
Each YHT-2210 tool has three crimping sections.
You can find which section should be used for
each terminal by the stamps on the dies.
(3) Squeeze handles gently until the connector is
held by the dies. Do not deform the terminal at
this stage.
seam _ _-...
terminal-~~~~iJ
of alignment of the teminal barrel
with the die.
Position a connector here making sure
1.25 2.0 5.5
. l