Download Print this page

Advertisement

Quick Links

BRITA VIVREAU VITAP SERIES
EN Original operating manual

Advertisement

loading
Need help?

Need help?

Do you have a question about the VIVREAU VITAP Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Brita VIVREAU VITAP Series

  • Page 1 BRITA VIVREAU VITAP SERIES EN Original operating manual...
  • Page 2 GENERAL INFORMATION VIVREAU VITAP This instruction manual is valid for the following products: The VIVREAU ViTap water dispenser product range VIVREAU ViTap 301 VIVREAU ViTap 302 VIVREAU ViTap 301 (ViTap 301-G-1-TS-0) The VIVREAU ViTap water dispensers are currently available in various per- VIVREAU ViTap 302 (ViTap 302-G-2-TS-0) formance options.
  • Page 3 SAFETY INSTRUCTIONS Important safety instructions. Please read these safety using CO gas cylinders” stick- • Have defective parts – to instructions carefully before using the appliance. Keep er in the immediate proximity which pressure is applied this manual in a convenient place so you can always refer to it of the CO bottle).
  • Page 4 SAFETY INSTRUCTIONS and cause substantial property have free access and can Danger of injury through Cleaning and maintenance may damage. be monitored by trained slipping in puddles of water! not be carried out by children. • Always have installation and personnel.
  • Page 5 SAFETY INSTRUCTIONS • The operator is familiar with Operator’s duties hygiene, health and safety as Aquastop the hygiene regulations The water dispenser is used well as environmental protec- The aquastop is located be- applicable to the operation of on commercial premises. For tion at the place of use must tween the water shut-off valve a beverage dispenser.
  • Page 6 SAFETY INSTRUCTIONS pressure regulator and BRITA GmbH. The device The following environmentally pressure relief valve must be connected to the hazardous substances are used: The CO pressure regulator is water supply using new pipes Refrigerants could contain mounted on the CO bottle.
  • Page 7 For more information, see “Safety Instructions”, page 4. In the event that public authorities request that the mains water must be boiled, this also applies to BRITA filtered water. USED SYMBOLS STORAGE VIVREAU ViTap 304 VIVREAU ViTap 305...
  • Page 8 USING THE DEVICE Please observe the foldout page! Startup On/Off Dispensing water VIVREAU ViTap 301 VIVREAU ViTap 302 Caution: Ensure that the device has Plug the device Available buttons on the tap Dispensing hot water: been standing upright for 24 hours into an adequate depending on the model: before starting up! Danger of dam-...
  • Page 9 USING THE DEVICE Please observe the foldout page! Portion setting VIVREAU ViTap 301 VIVREAU ViTap 302 When the circumstanc- Preset a dispensing quantity: Dispensing preset Reset dispensing quantity: es allow the setting for portion: one particular portion a 1. Set a suitable vessel under 1.
  • Page 10 INACTIVE PERIODS MAINTENANCE Before inactive periods longer than 3 days Schedule Before the water dispenser is due to experience an For the optimum and trouble-free If increased wear is identified during inactive period of more than 3 days, proceed as follows: operation of the water dispenser, routine checks, the required intervals please make sure to carry out the...
  • Page 11 MAINTENANCE Please observe the foldout page! Cleaning drip tray Cleaning outlet tap Cleaning housing / tap Check CO bottle VIVREAU ViTap 301 VIVREAU ViTap 302 1. Remove the 1. Unscrew the Cleaning the surface Check the fill level of the bottle grid.
  • Page 12 REPLACING CO GAS BOTTLE Safety instructions for using CO gas cylinders. 12 steps to change the CO cylinder safely: Not following these instructions may lead to serious or fatal injuries! 1. CO bottle is empty (check E2 for 9. Tighten nut F with spanner. En- Always connect the CO cylinder to Danger! CO...
  • Page 13 WHAT TO DO IN AN EMERGENCY Water leakage 1. Disconnect the 2. Shut off the water dispenser water supply and from the power collect the leaked supply. water. Refrigerant leakage WARNING! 1. Disconnect the 2. Shut off the Danger to health 3.
  • Page 14 TROUBLESHOOTING IDENTIFICATION PLATE Response to possible problems The identification plate is on the back of the appliance. WARNING! Danger of injury from repair work! The water dispenser contains no parts that can be repaired by the operator. Tasks other than those described in these instructions may only be carried DISMANTLING AND DISPOSAL out by the manufacturer or by a qualified person.
  • Page 15 TECHNICAL DATA Specifications may vary due to further development and improvement of the V­Boiler products. Dimensions (W x H x D) 130 x 523 x 320 mm Hot water storage capacity 4.5 l Technical conditions Hot water dispensing capacity max. 3-4 cups/min. at up to 95° C Voltage 220-240 V Hot water immediate dispense...
  • Page 16 Telephone: + 31 (0)88 111 7 111 Telefax: + 31 (0)88 111 7 123 Internet: www.brita.net Belgium BRITA Vivreau BV BA De Keyserlei 58-60/Bus19 2018 Antwerpen Belgium Telephone: + 32 (0)7 81 50 277 Telefax: + 32 (0)7 81 50 278 Internet: www.brita.net...
  • Page 17 VIVREAU V 301 (V -1) – CONNECTION SCHEME Article description Qty. Standpipe DZR Brass 3/4 (UK only) Aquastop Standpipe w/ washer 3/4“ BSPF Valve PRV-DCV-Comb Straight BSPTF Flat 3/4-JG3/8 Elbow 90° Stem JG3/8-JG5/16 Shut Off Valve JG8 Tube LLDPE black JG5/16 Insulation pipe 2 m Filterhead CLARITY HS1: 1 x Filterhead incl.
  • Page 18 VIVREAU V 302 (V -2) – CONNECTION SCHEME Article description Qty. Standpipe DZR Brass 3/4 (UK only) Aquastop Standpipe w/ washer 3/4“ BSPF Valve PRV-DCV-Comb Straight BSPTF Flat 3/4-JG3/8 Elbow 90° Stem JG3/8-JG5/16 Shut Off Valve JG8 Tube LLDPE black JG5/16 Insulation pipe 2 m Filterhead CLARITY HS1: 1 x Filterhead incl.
  • Page 19 VIVREAU V 303 (V -H) – CONNECTION SCHEME Article description Qty. Standpipe DZR Brass 3/4 (UK only) Aquastop Standpipe w/ washer 3/4“ BSPF Filterhead 0-70% JG8 PURITY Valve PRV-DCV-Comb Straight BSPTF Flat 3/4-JG3/8 Elbow 90° Stem JG3/8-JG5/16 Shut Off Valve JG8 Tube LLDPE black JG5/16 Insulation pipe 2 m PURITY C500 Dispenser...
  • Page 20 VIVREAU V 303 Max (V -H Max) – CONNECTION SCHEME Article description Qty. Standpipe DZR Brass 3/4 (UK only) Aquastop Standpipe w/ washer 3/4“ BSPF Elbow 90° Stem JG5/16-JG5/16 Valve PRV-DCV-Comb Straight BSPTF Flat 3/4-JG3/8 Shut Off Valve JG8 Elbow 90° Stem JG3/8-JG5/16 Tube LLDPE black JG5/16 Insulation pipe 2 m PURITY C1100 Dispenser...
  • Page 21 VIVREAU V 304 (V -1H) – CONNECTION SCHEME Article description Qty. Standpipe DZR Brass 3/4 (UK only) Aquastop Standpipe w/ washer 3/4“ BSPF Elbow 90° Stem JG5/16-JG5/16 Valve PRV-DCV-Comb Straight BSPTF Flat 3/4-JG3/8 Elbow 90° Stem JG3/8-JG5/16 Shut Off Valve JG8 Tube LLDPE black JG5/16 Insulation pipe 2 m Tee JG5/16...
  • Page 22 VIVREAU V 304 Max (V -1H Max) – CONNECTION SCHEME Article description Qty. Standpipe DZR Brass 3/4 (UK only) Aquastop Standpipe w/ washer 3/4“ BSPF Elbow 90° Stem JG5/16-JG5/16 Valve PRV-DCV-Comb Straight BSPTF Flat 3/4-JG3/8 Elbow 90° Stem JG3/8-JG5/16 Shut Off Valve JG8 Tube LLDPE black JG5/16 Insulation pipe 2M Tee JG5/16...
  • Page 23 VIVREAU V 305 (V -2H) – CONNECTION SCHEME Article description Qty. Standpipe DZR Brass 3/4 (UK only) Aquastop Standpipe w/ washer 3/4“ BSPF Elbow 90° Stem JG5/16-JG5/16 Valve PRV-DCV-Comb Straight BSPTF Flat 3/4-JG3/8 Elbow 90° Stem JG3/8-JG5/16 Shut Off Valve JG8 Tube LLDPE black JG5/16 Insulation pipe 2 m Tee JG5/16...
  • Page 24 VIVREAU V 305 Max (V -2H Max) – CONNECTION SCHEME Article description Qty. Standpipe DZR Brass 3/4 (UK only) Aquastop Standpipe w/ washer 3/4“ BSPF Elbow 90° Stem JG5/16-JG5/16 Valve PRV-DCV-Comb Straight BSPTF Flat 3/4-JG3/8 Elbow 90° Stem JG3/8-JG5/16 Shut Off Valve JG8 Tube LLDPE black JG5/16 Insulation pipe 2 m Tee JG5/16...
  • Page 25 BRITA GmbH Heinrich­Hertz­Str. 4 65232 Taunusstein Germany www.brita.net 1032392-02-ELA 03/21...
Save PDF