Remote Management - ZyXEL Communications ES3500-24 User Manual

Chapter 38 Access Control
the Remote Management screen (discussed later). Click Management > Access Control >
Service Access Control to view the screen as shown.
Figure 184 Management > Access Control > Service Access Control
The following table describes the fields in this screen.
Table 129 Management > Access Control > Service Access Control
LABEL
Services
Active
Service Port
Timeout
Apply
Cancel

38.11 Remote Management

Click Management > Access Control > Remote Management to view the screen as shown
next.
304
DESCRIPTION
Services you may use to access the Switch are listed here.
Select this option for the corresponding services that you want to allow to access the
Switch.
For Telnet, SSH, FTP, HTTP or HTTPS services, you may change the default service
port by typing the new port number in the Server Port field. If you change the
default port number then you will have to let people (who wish to use the service)
know the new port number for that service.
Type how many minutes a management session (via the web configurator) can be left
idle before the session times out. After it times out you have to log in with your
password again. Very long idle timeouts may have security risks.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
ES3500-24 User's Guide