Bandwidth Control Setup - ZyXEL Communications ES3500-24 User Manual

Chapter 14 Bandwidth Control

14.2 Bandwidth Control Setup

Click Advanced Application > Bandwidth Control in the navigation panel to bring up the screen
as shown next.
Figure 62 Advanced Application > Bandwidth Control
The following table describes the related labels in this screen.
Table 35 Advanced Application > Bandwidth Control
LABEL
Active
Port
*
Ingress Rate
Active
Commit
Rate
Active
Peak Rate
Active
Egress Rate
136
DESCRIPTION
Select this check box to enable bandwidth control on the Switch.
This field displays the port number.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first
to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select this check box to activate commit rate limits on this port.
Specify the guaranteed bandwidth allowed in kilobits per second (Kbps) for the incoming
traffic flow on a port. The commit rate should be less than the peak rate. The sum of commit
rates cannot be greater than or equal to the uplink bandwidth.
Select this check box to activate peak rate limits on this port.
Specify the maximum bandwidth allowed in kilobits per second (Kbps) for the incoming traffic
flow on a port.
Select this check box to activate egress rate limits on this port.
Specify the maximum bandwidth allowed in kilobits per second (Kbps) for the out-going traffic
flow on a port.
ES3500-24 User's Guide