ZyXEL Communications ES-3124PWR User Manual page 60

Chapter 4 The Web Configurator
Table 6 Navigation Panel Links (continued)
LINK
Spanning Tree
Protocol
Bandwidth
Control
Broadcast Storm
Control
Mirroring
Link Aggregation This link takes you to a screen where you can logically aggregate physical links to
Port
Authentication
Port Security
Classifier
Policy Rule
Queuing Method
VLAN Stacking
Multicast
Auth and Acct
IP Source Guard This link takes you to a screen where you can configure filtering of unauthorized
Loop Guard
IP Application
Static Route
DiffServ
DHCP
Management
Maintenance
Access Control
Diagnostic
60
DESCRIPTION
This link takes you to screens where you can configure the RSTP/MRSTP/MSTP to
prevent network loops.
This link takes you to screens where you can cap the maximum bandwidth allowed
from specified source(s) to specified destination(s).
This link takes you to a screen to set up broadcast filters.
This link takes you to screens where you can copy traffic from one port or ports to
another port in order that you can examine the traffic from the first port without
interference
form one logical, higher-bandwidth link.
This link takes you to a screen where you can configure IEEE 802.1x port
authentication as well as MAC authentication for clients communicating via the
Switch.
This link takes you to a screen where you can activate MAC address learning and
set the maximum number of MAC addresses to learn on a port.
This link takes you to a screen where you can configure the Switch to group
packets based on the specified criteria.
This link takes you to a screen where you can configure the Switch to perform
special treatment on the grouped packets.
This link takes you to a screen where you can configure queuing with associated
queue weights for each port.
This link takes you to a screen where you can configure VLAN stacking.
This link takes you to a screen where you can configure various multicast features
and create multicast VLANs.
This link takes you to a screen where you can configure authentication and
accounting services via external servers. The external servers can be either
RADIUS (Remote Authentication Dial-In User Service) or TACACS+ (Terminal
Access Controller Access-Control System Plus).
DHCP and ARP packets in your network.
This link takes you to a screen where you can configure protection against network
loops that occur on the edge of your network.
This link takes you to screens where you can configure static routes. A static route
defines how the Switch should forward traffic by configuring the TCP/IP parameters
manually.
This link takes you to screens where you can enable DiffServ, configure marking
rules and set DSCP-to-IEEE802.1p mappings.
This link takes you to a screen where you can configure the DHCP settings.
This link takes you to screens where you can perform firmware and configuration
file maintenance as well as reboot the system.
This link takes you to screens where you can change the system login password
and configure SNMP and remote management.
This link takes you to screens where you can view system logs and test port(s).
ES-3124 Series User's Guide