sensolus TRACK 1000 Battery Replacement Manual

Step 1
• Make sure that the serial number and logo are facing
the right way up.
• Then turn the tracker face down.
• Unscrew the 6 screws.
Tip: If using a power drill, use power se琀�ng 7, on low.
(Note: not all power drills have the same se琀�ngs!)
Step 4
Place the chip so the connector is towards the holder.
Step 7
Make sure that the seal is completely 昀氀at/intact on the
back of the tracker.
www.sensolus.com | info@sensolus.com
Step 2
• Remove the back plate and the 6 screws.
Step 5
Insert new ba琀琀eries. Posi琀椀on the new ba琀琀eries and make
sure the ba琀琀eries are in the center (on top of the sponge)
- not too low or too high.
Step 8
Close the case again by 琀椀ghtening the 6 screws in the
corresponding holes. Be careful not to break the casing
when using a power drill.
TRACK 1000 Battery replacement manual
Step 3
Remove the ba琀琀eries - pull them out of the
•
connector.
Tip: place a 昀椀nger on the sponge to hold it in place
Step 6
Make sure the connector is inside the holder and that the
cable is tucked to the le昀琀-hand side.
Step 9
The green light on the front of the tracker will rapidly
昀氀ash green. From this moment, your asset tracker will
start sending ac琀椀vity (movement) and GPS loca琀椀on.
This informa琀椀on will be visible in the Sensolus Pla琀昀orm
if you 昀椀nd yourself in an area with Sigfox communica琀椀on
network coverage.