sensolus TRACK 1141 Installation And Activation

Installation and activation manual TRACK 1141
Mounting the tracker
Guidelines how to mount the tracker can be found in the Sensolus documentation center.
Tracker activation
Activation of the trackers is preferably done with clear skies, and not inside (e.g. factory or warehouse).
Trackers are not activated when delivered to your premises.
Their subscription in the platform will start within six month of purchase.
Hold a magnet for about 5
seconds on top of the logo
on the asset tracker.
Activation troubleshooting
Activating a tracker that communicates over the NB-IoT network can sometimes come with a delay.
With a delay we mean that the online status doesn't appear within 5 minutes after holding the magnet to the tracker.
This is mostly due to conditions on the network operator site.
If the activation wasn't successful after 5 minutes the tracker will try again to activate again after waiting 24 hours.
This long period of time is often an obstacle to start installing trackers to assets and makes the timing of the installation of the trackers
cumbersome as it is important to only install trackers when they appeared as online on the platform.
To overcome to 24 hours waiting time, you can do the following:
if after 5 minutes of waiting and the status didn't change yet to "online'' hold the magnet again for 5 seconds on top of the tracker to enforce a
new attempt for activation. Keep trying every 5 minutes until the Online status appears.
www.sensolus.com | info@sensolus.com
You will first see a red
LED. Do not remove the
magnet yet.
When the green LED is
blinking you can remove
the magnet.
Your tracker is ready for
use.
April 3, 2025 6:02 PM