Related Manuals for Clarke VAC KING ASHVAC1200B
Summary of Contents for Clarke VAC KING ASHVAC1200B
- Page 1 ELECTRIC ASH-VAC MODEL NO: ASHVAC1200B PART NO: 6471134 OPERATING & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS DL10/23...
- Page 2 INTRODUCTION Thank you for purchasing this CLARKE product which is designed for fast, easy removal of cold ash from stoves and fireplaces. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service.
- Page 3 Power Cable Length 4.15m Please note that the details and specifications contained herein are correct at the time of going to print. However CLARKE International reserve the right to change specifications at any time without prior notice. GENERAL SAFETY PRECAUTIONS Prior to use, all users should become familiar with these instructions.
- Page 4 2. NEVER use this product if any part is damaged. Have it inspected and repaired by your CLARKE dealer. DO NOT use if the power cable, plug, or the machine itself, is in poor condition. 3. NEVER abuse the power cable. NEVER pull on the cable when removing the plug from the socket or lift the ash-vac by the power cable.
- Page 5 ELECTRICAL CONNECTIONS WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS THOROUGHLY BEFORE CONNECTING THE PRODUCT TO THE MAINS SUPPLY. Before switching the product on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate. This product is designed to operate on 230VAC 50Hz.
- Page 6 COMPONENTS When unpacking please check contents and advise your dealer immediately if any parts are missing. The essential components are as follows. NO DESCRIPTION NO DESCRIPTION Tank Suction Tube with Crevice End Motor/Lid Assembly Suction Tube with Straight End Suction Hose Parts &...
- Page 7 PREPARATION FOR USE 1. With the ash-vac removed from the packaging, undo the securing clips securing the lid assembly and remove the components from within the tank. Check for shortages and that no damage was suffered in transit. 2. Replace the lid assembly on top of the tank and close the clips 3.
- Page 8 2. Switch on the ash-vac and use the suction tube to collect the ash. 3. When moving the ash-vac: • ALWAYS use the handle. • DO NOT lift it by (or place a strain on) the hose or power cable. •...
- Page 9 6. Replace the filter, lid and wingnut back in place. • Contact your CLARKE dealer for replacement filter if required. CARE & STORAGE 1. When not in use, turn off using the switch on top of the ash-vac, then unplug from the power supply.
- Page 10 PARTS DIAGRAM Ref No Description On/Off Switch Top Cover Housing Power Cord Sponge Filter Capacitor Seal cap Motor Rubber seal Motor Housing Top Cover Air Inlet Board Screws HEPA Filter HEPA Cover Tank Crevice Suction Tube Straight Suction Tube Suction Hose Parts &...
- Page 11 DECLARATIONS OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the VAC KING ASHVAC1200B and is the answer not in the manual?
Questions and answers