Delta DVP-EX2 Operation Manual page 306

Hide thumbs Also See for DVP-EX2:

D V P - E S 2 / E X 2 / E C 5 / S S 2 / S A 2 / S X 2 / S E / S E 2 & T P O p e r a t i o n M a n u a l - P r o g r a m m i n g

Explanations:

When M0 is triggered, Y0 executes pulse output. When external interrupt is detected on X4

after 50,000 pulses, pulse output will perform ramp down process for 10,000 pulses and

then stop. M1108 will be ON. If no interrupt is detected on X4, Y0 pulse output will stop

after 1,000,000 pulses are completed.

Interrupt triggered between 0-50,000 pulses will be invalid, i.e. no ramp-down process will

be performed before 50,000 pulses are achieved.

Points to note:

When Mark function is executed with Mask function, PLC will check the validity of Mask

range first, then ramp-down stop pulses of Mark function. If the above set values exceed

the proper range, PLC will automatically modify the set values after the instruction is

When PLSR or positioning instructions with ramp-up/down section are enabled, the user

can check the pulses of ramp-up section in DD1127 and pulses of ramp-down section in

Users can perform single speed positioning when ramp-up/down time setting is not

Adding mask and alignment mark function for CH0 and CH1

Available for the followings

CH0 and CH1 relative parameters for Mask and Alignment Mark function:

deceleration

Number of ramp-

after marking

Need help?

Do you have a question about the DVP-EX2 and is the answer not in the manual?