Nova 9605-R How To Assemble

HOW TO
ASSEMBLE YOUR
BATH SEAT BASKET
Item # 9605-R
Capacity not to exceed 5 lb.
1 Remove all parts from box. (Be sure all parts are included before assembling)
A. (1) Basket
B. (2) Basket hooks
C. (1) Screw set (2 Long screws,
2 Short screws, 4 Washers, 4 Nuts)
PHILLIPS SCREWDRIVER
2
Clip the 2 "Basket hooks" onto the 2 front legs of
your bath bench. The long end of the clips with the
screw holes must point behind the legs. The hooks
must point downwards and must face each other
inside of the legs. Slide both "Basket hooks" up to
the gray plastic silencers at the top of the legs to
ensure the hooks are leveled with each other.
Place and fit a "Nut" into the hexagon shaped cutout
3
of the "Basket hook". On the opposite end, insert a
"Long screw" through a "Washer", slide the screw
through both holes, and while holding the "Nut" in
place, screw it through the "Nut". Do not over tighten
so that you can swivel and make adjustments to
the "Basket hook". NOTE: The "Basket hooks" can
also clip onto the frame above the legs. Due to the
smaller tube diameter, use the "Short screws" for
this option.
Place the "Basket" onto the "Basket hooks"
4
with the sloped end of the "Basket" facing
forward. The arrows in the image show other
placement options. Push the "Basket" down
into the "Basket hooks" so that it snaps and
clips in place. Once everything is secure,
tighten the screws so that the "Basket hooks"
do not move.
TOOL NEEDED:
QUICK ASSEMBLY
Follow these
SIMPLE STEPS
A.
B.
SILENCER
C.