Subscribe to Our Youtube Channel
Related Manuals for Discount Car Stereo BTA-V0L2
Summary of Contents for Discount Car Stereo BTA-V0L2
- Page 1 Courtesy of: DiscountCarStereo.com Serving the internet community since 1995 Created: August 2018 Revised: December 20, 2024...
- Page 2 PRODUCT SAFETY & DISCLAIMER READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY • This document is provided as a GENERAL installation guide, some vehicles vary and may require additional steps. We do not accept responsibility for third party labor charges or modifications.
- Page 3 3. Remove the ignition control module (ICM) – See Fig. 3. It is secured by two hidden clips (one on each side). Grip with both hands and pull then disconnect the two plugs. Put display to one side Fig. 5 6.
- Page 4 Fig. 7 8. Pry up cover in rear storage compartment and remote two screws (Torx 25) (See Fig. 8 & 9) Fig. 9 9. Carefully detach hand-brake panel and remove (See Fig. 10) Fig. 8 Fig. 10 10. Remove two screws from top edge of center console (See Fig.
- Page 5 Fig. 13 Fig. 11 12. Remove two screws (Torx 25) as seen in Fig. 14. 11. Carefully pry up the lock catch using pry tool or flat screwdriver (See Fig. 12). At the same time, slide the whole tunnel console backwards so to gain access to the two rear screws on center console's panel.
- Page 6 Fig. 17 16. Connect installation harness 14-pin Male plug (See Fig. 18) to CD player/changer slot vacated in step 15. (See Fig. 18) Fig. 15 Ensure plug is fit snug otherwise speaker may play intermittently. 14. Remove two screws (Torx 25) securing CD player to dash. Fig.
- Page 7 Fig. 19 18. Place Bluetooth module behind radio cavity Fig. 21 19. Route (red) accessory wire to cigar lighter outlet or other circuit controlled by ignition switch and use included T-Tap to make the connection. Remove the two Torx screws. See Fig.
- Page 8 8. Connect factory 14-pin male plug (removed in step 6) to installation harness 14-pin connector (See Fig. 26) Fig. 23 Fig. 26 Press release tab on factory 14-pin gray plug and disconnect from CD player. (See Fig. 24). 9. Place Bluetooth module behind radio cavity 10.
- Page 9 Operation Reconnect display module and climate control panel to green plug. Turn ignition to position II Turn ignition and radio “ON” Press “MODE” button until AUX AUDIO INPUT is displayed (See Fig. 30) Fig. 28 12. Reinstall radio by reversing install steps Pairing Fig.
- Page 10 For additional questions, email support@discountcarstereo.com © 1995-Dec-24 Discount Car Stereo, Inc. All rights reserved. Information in this document is subject to change without notice. Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark holders.
Need help?
Do you have a question about the BTA-V0L2 and is the answer not in the manual?
Questions and answers