Tech Controllers EU-WiFi X User Manual page 15

3.3. HEATING - COOLING
3.3.1. OPERATING MODE
➢ Automatic – varies depending on the heating/cooling input - if there is no signal, it works in heating mode
➢ Heating – the zone is heated
➢ Cooling – the zone is cooled
3.4. PROTECTION - HUMIDITY
Protection – humidity – If the humidity in the zone is higher than the value set in emodul.eu, cooling in this zone will be
turned OFF.
NOTE
The function only works in "Cooling" mode.
3.5. FACTORY SETTINGS
The function allows you to restore the factory settings of the controller and deregisters the regulator.
4. SERVICE MENU
The service menu is available only to qualified installers and is protected by a code that can be made available by the Tech
Sterowniki service. When contacting the service, please provide the controller software version number.
5. STATISTICS TAB
The Statistics tab enables the user to view the temperature charts for different time periods e.g. 24h, a week or a month.
It is also possible to view the statistics for the previous months.
15
En example chart