Bowflex SelectTech 552 Troubleshooting Manual

3/11/24, 9:17 AM
SelectTech 552 Dumbbells: Why doesn't the handle fit in the base?
Follow this troubleshooting guide to help fully insert the handle of your SelectTech 552 Dumbbells in the base.
Some common complaints may include:
Handle doesn't fit in base
Handle wont insert in base
Handle or base won't lock
Follow these steps to troubleshoot the issue
1.
Set your dumbbell on the floor or another firm and level surface. Flip your dumbbell over to expose the black locking
mechanism button (reference 1).
2.
Carefully press on the black locking mechanism button with a blunt object. Hold the button down while turning the
dial to the lowest setting.
3.
Remove each weight plate from the handle and thoroughly inspect for damage. Pay special attention to the weight
selection tabs.
4.
Re-insert the plates into the base. Make sure they are all facing the same direction and align properly. The tabs should
all face the outer ends of the base. The plates should be easily removed and put back into place [11886.A]. If any
plates are damaged,
5.
If the issue persists, remove all weight plates from the base. Retest the handle in the base and add 1 pair of weight
plates at a time. Retest the handle in the base with each pair added [11886.C]. If the issue persists when a particular
plate is added, order a Weight Plate
everything, order a Handle
6.
Once all parts are reassembled, perform a lock test
test? [11886.F]
about:blank
SelectTech 552 Dumbbells:  Why doesn't the handle fit in the base?
The red arrow indicates the location of the locking mechanism button.
order a Weight Plate for the affected plate [11886.B].
for the affected plate [11886.D]. If the issue persists after reassembling
Assembly [11886.E].
(Reference 1)
here: SelectTech Dumbbells: How do I perform a lock
ID: 11886.1
1/2