OLIGHT Warrior X Turbo Manual

Table of Contents

Contents

1 IN THE BOX
2 SPECIFICATIONS
3 USB MAGNETIC CHARGING CABLE -- MCC3
4 PRODUCT OVERVIEW
5 BEFORE FIRST USE
6 CHARGING
7 HOW TO OPERATE
8 Documents / Resources
- 8.1 References
- 8.2 Download manual

IN THE BOX

SPECIFICATIONS

All above specifications are test results based on ANSI/NEMA FL1-2009 Standard. The tests are performed using the battery included in the flashlight. Note: The maximum output brightness will decrease as the battery voltage decreases.

USB MAGNETIC CHARGING CABLE -- MCC3

Parameter	Specification
Charging cable	USB Type A - magnetic charging connector, length: 0.5m
Input	USB A - Type DC 5V 2A
Charging pattern	CC&CV
Maximum charging current	2A
Full-capacity charging voltage	4.2V±0.05V
Charge indication	Red: charging Green: full (over 95%) or disconnected with flashlight
Time to fully charge	5.5 hours (For reference only. When the USB power source is insufficient to provide 5V 2A power capacity, the charging time will be longer)

PRODUCT OVERVIEW

BEFORE FIRST USE

Before first use, please remove the protective film on the lens; and please also unscrew the tailcap to remove the insulating film within the battery compartment, then screw the tailcap back on tightly. If the battery needs to be changed, make sure that the positive polarity side of the battery faces the flashlight head (the side of the LED).
BEFORE FIRST USE

CHARGING

Vibrating Power Indicator
It helps to alert if the battery is low (power<20% vibrate once every 5 minutes; power<10% vibrate once per minute; power<5% vibrate once every 10 seconds).

Before first use please fully charge the product.
Connect the USB Type-A end of the magnetic charging cable (MCC3) to an external USB power source, then attach the magnetic end to the magnetic charging port of the flashlight (best charging efficiency with a 10W (5V 2A) USB power source). The red indicator means charging, while the green indicator means charging completed (battery level 95%).
Only to charge with standard MCC3. NOT compatible with other MCC.

Tactical Grip Ring (TGR) Replacement Guide

Unscrew the tailcap and remove the O-ring.
Then remove the metal TGR and pocket clip.
Install the silicone TGR and O-ring as shown in the picture and tighten the tailcap.

DO NOT throw the light directly into human eyes. This may cause temporary blindness, or permanent damage to the eyes.
DO NOT cover the flashlight's head or stand the flashlight on its head when it is on. The radiation energy may cause damage to the flashlight itself, or even result in the burning of flammable objects nearby.
DO NOT use non-protected rechargeable batteries.

Keep out of reach of children.
DO NOT activate high mode repeatedly under high temperature to prevent the flashlight body from overheating and hurting the user's hand.
The tail switch may not work while immersed in seawater or other conductive media. Please try to keep it clean and dry.
If the product is left unused or carried and transported, please loosen the tailcap a half turn to avoid accidentally activating the flashlight.

NOTICE

DO NOT short-circuit the switch cap with the ring surrounding it. The short circuit in this case will result in an electric discharge of below 6mA between them, and may lead to a complete battery drain if it is in this state for too long.

HOW TO OPERATE

Click the tail switch lightly to produce a low light output or press the tail switch hard to produce a high light output.
Single click (click and release quickly) the tail switch to turn the flashlight on or off.
When you press and hold the switch, the flashlight will be in momentary mode; when you release the tail switch, it will turn off.

USA Customer Support
cs@olightstore.com
Global Customer Support
customer-service@olightworld.com
Visit www.olightworld.com to see our complete product line of portable illumination tools.