OLIGHT SR MINI INTIMIDATOR II - 3200 Lumens Rechargeable Flashlight Manual

OLIGHT SR MINI INTIMIDATOR II - 3200 Lumens Rechargeable Flashlight Manual

Advertisement

OLIGHT SR MINI INTIMIDATOR II - 3200 Lumens Rechargeable Flashlight Manual

INSIDE THE BOX

Flashlight, holster, USB cable, user manual (this manual), and other optional accessories( refer to the label marks outside of box for detail)

SUPPORTED BATTERIES

3 x 18650 rechargeable lithium batteries with protecting circuit board, the batteries must have a protruding button on positive pole.

OPERATION INSTRUCTION

  • BATTERY INSTALLATION
    Before use, install the batteries and notice that the battery positive towards the flashlight head, then tightly screw the tail-cap as shown below.
    OPERATION INSTRUCTION - Step 1
  • TURN ON/OFF
    Quick click the side switch to turn the flashlight on or off. The light will turn to the last output mode before shutting off.
  • CHANGE BRIGHTNESS LEVELS
    With the light on, press and hold the side switch, the output will cycle through low, medium, and high brightness levels. Release the side switch when the desired brightness level is achieved.
  • LOW MODE
    With light off, press and hold the side switch for more than 1 second, the low mode will be activated.
  • TURBO MODE
    Double-click the side switch to activate turbo mode if the light is in nonlocking state.
  • STROBE MODE
    When the light is in non-lock state, Triple-click side switch to activate strobe mode. Click the side switch once to quit strobe mode, press and hold side switch to turn on the setting of changing brightness level.
  • LOCK MODE
    With the light off, press the side switch and hold for 1 second to activate low mode, keep holding the switch for one more second, the light will shut off automatically and lock the side switch. Under lock state, click and release the switch, the red indicator will last for 2 seconds.
  • UNLOCK MODE
    When the light is off, press and hold side switch for more than 2 seconds, the switch is enable and activate low mode. User may twist the tail cap anticlockwise to turn off the light, tighten the tail cap clockwise to unlock the light.
  • STATUS INDICATOR
    There is a multi-purpose status indicator lamp at the upside of the USB charging port to indicate the battery low voltage or charging state:
    Battery low voltage indication: When the battery voltage is less than 3.25V, the status indicator lamp will flicker in red; when the battery voltage is less than 3.05V, the status indicator lamp will be a constant red.
    Charging state indication: red means under charging; green means fully charged.
  • BATTERY CHARGE
    Firstly, slide the USB port cover aside, then connect the flashlight to external USB power supply, the status indicator turn on means charging is in process.
    NOTE: One of the following output modes low, medium, high, will be memorized when the light shutting off. The flashlight will not memorize the low mode when the light is activated to low mode directly before it is turned off. For high mode, the light will only memorize high mode for 10 minutes when the light is off, after 10 minutes the memorized mode will switch to medium mode.
    OPERATION INSTRUCTION - Step 2


Do not mix rechargeable and non-rechargeable batteries.
Do not mix batteries of different types/brands.

Properly install the batteries, the positive of battery towards the head of the flashlight, three batteries are in same direction.

The product only support the batteries with protruding button on the positive and with protecting circuit board, recommend to use the battery cell capacity of 18650 with 3000mAh or above.

Low battery protection: if the battery v oltage drop down to 2.7V, the flashlight will not turn on, the indicator will emit red color when the switch is pressed.

Use caution for long runtimes at high level and turbo as flashlight may get hot.

Three batteries are parallelly connected inside the flashlight, either 1 or 2 or 3 batteries are able to turn the flashlight on, it is better not to use Turbo when using 1 or 2 batteries, it may cause to suddenly shut down due to battery protection.

Please choose 5V 2.1A USB power supply or higher rate power supply to charge the flashlight.

SPECIFICATIONS



Output

TURBO 3,200 lumens
HIGH 1,600 lumens / 3 hours
MED 600 lumens / 8 hours
LOW 120 lumens / 36 hours
STROBE 10Hz
LED 3xCree XM-L2 CW
Operate Voltage 2.8 to 6v
Candela 18,000cd
Beam Distance 268 meters
Supported Batteries 3 x 18650 (with protecting circuit board)
Material Type Ⅲ hard anodized aluminum
Water-proof IPX
Impact Resistance 1.5 meters
Dimensions 132 47.5 /.2
Weight 181g / 6.4oz (excluding batteries)

CONTACT

Technical support: techsupport@olightworld.com
Customer service: cs@olightworld.com
Website: www.olightworld.com
www.DrMemory.com/Olight

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download OLIGHT SR MINI INTIMIDATOR II - 3200 Lumens Rechargeable Flashlight Manual

Advertisement

Need Assistance?

Do you have a question about the SR MINI INTIMIDATOR II that isn't answered in the manual? Leave your question here.

Error while submitting your question. Please, reload page and try again.

Thank you! Your question has been received!

Table of Contents