Setting The Clock; Operating The Radio - Sangean U-3 Operating Instructions Manual

Setting the clock

1. Clock can be set either the radio is power on or off.
2. Display will show "- : - -" when the batteries are installed or when
the radio is connected to the mains supply.
3. Press in Tuning control (Time Set) knob for more than 2 seconds,
display will flash time set symbol
followed by a beep.
4. Rotary Tuning Control (Time Set) knob to set the required hours.
5. Press in Tuning control knob, the minute digits will flash.
6. Rotary Tuning Control button to set required minute.
7. Press in Tuning Control button to complete time setting.

Operating the radio

This radio is equipped with three tuning methods – Scan tuning,
Manual tuning and Memory presets recall.
Scan Tuning
1. Press the Power button to turn on the radio.
2. Select the required waveband by pressing the Band button.
For FM band, be sure to screw in the rubber FM antenna properly
to get best reception. For MW (AM) band, rotate the radio to get
best signal.
3. Press and release Tuning Control /Time Set /Scan knob
(long press the knob more than 2 seconds will activate time
setting), the radio will up search and stop automatically when
it finds a radio station. Press the Scan button again to pick up
the found station.
and also the hour digits,
GB
8