Sangean U-3 Operating Instructions Manual page 12

Note:
Radio alarm can be activated only until both radio alarm time and
radio alarmed station are set. Radio alarm will be automatically
switched to Buzzer alarm when the radio is in low battery status
or the selected radio alarm station signal is too weak.
a. Setting radio alarm time:
1. The radio alarm can be set either radio is on or off.
2. Press and release radio alarm button
will flash.
3. During radio alarm flashing, press Tuning control/Scan/Time Set
knob for more than 2 seconds followed by a beep tone.
4. Display Hour will flash, rotate Tuning Control knob to select the
hour then press in Tuning control/Scan/Time Set knob again to
confirm hour setting.
5. Follow same procedure of setting hour to set required minute.
Press Tuning Control/Scan/Time Set knob again to complete
alarm time setting.
b. Setting radio alarmed station:
1. During setting radio alarm time and radio alarm symbol is flashing,
press Band button to activate the radio to select required wake-up
band and station by manual tuning and recall preset stations.
2. When above radio alarm time and station are set, press and hold
radio button
alarm on or off. Display will show
Note:
If new radio alarm station is not selected, it will select the last
alarm station.
11
for 2 seconds followed by a beep tone to switched
, the radio alarm symbol
when radio alarm is set.