Sangean U-3 Operating Instructions Manual page 13

Utility radio fm/am 2 band ultra rugged digital tuning radio receiver

Hide thumbs Also See for U-3:

Table of Contents

Available languages

Setting the HWS (Humane Wake System)

buzzer alarm

A beep tone will activate when selecting the HWS alarm.

The alarm beep will increase in volume every 15 seconds for one

minute followed by one minute silence before repeating the cycle.

The HWS buzzer alarm will sound for one hour until turning off by

pressing the Power button. Press the Power button whilst the alarm

is activated will cancel the alarm for 24 hours.

1. The HWS buzzer alarm can be set either radio is on or off.

2. Press and release the HWS buzzer alarm button

the symbol

3. During the symbol flashes, long press the Tuning Control/Scan/

Time Set knob for more than 2 seconds followed by a beep tone.

Display Hour digit will flash.

4. Rotate Tuning Control knob to select required alarm hour, then

press in Tuning Control knob again. The minute digit will then flash.

5. Rotate Tuning Control knob to select required alarmed minute the

press in Tuning Control knob to complete alarm setting.

6. Press and hold down HWS buzzer alarm button

2 seconds followed by a beep tone to switch on or off the alarm.

Display will appear

will flash.

when HWS buzzer alarm has been set.

for more than

Table of Contents